// Copyright 2019 The Fuchsia Authors. All rights reserved.
// Use of this source code is governed by a BSD-style license that can be
// found in the LICENSE file.

library fuchsia.hardware.goldfish;

using zx;

/// Signal that will be active on event handle if the Read() method
/// will return data.
const uint32 SIGNAL_READABLE = 0x01000000; // ZX_USER_SIGNAL_0

/// Signal that will be active on event handle if the Write() method
/// will accept data.
const uint32 SIGNAL_WRITABLE = 0x02000000; // ZX_USER_SIGNAL_1

/// Signal that will be active on event handle if the device has been
/// disconnected.
const uint32 SIGNAL_HANGUP = 0x04000000; // ZX_USER_SIGNAL_2

/// Interface for the Goldfish pipe driver.
[Layout = "Simple"]
protocol PipeDevice {
    /// Open pipe. A protocol request `pipe_request` provides an interface
    /// to the pipe. Multiple pipes can be opened for a single device.
    /// Closing the device connection will also close all pipe connections.
    /// TODO(DX-1766): Unify `device` and `pipe`.
    OpenPipe(request<Pipe> pipe_request);
};

[Layout = "Simple"]
protocol Pipe {
    /// Request new IO buffer size. Can fail if out of memory. Discards
    /// contents of existing buffer on success. Leaves existing buffer
    /// intact on failure.
    SetBufferSize(uint64 size) -> (zx.status res);

    /// Set event used to signal device state. Discards existing event
    /// after having transferred device state to the new event.
    SetEvent(handle<event> event);

    /// Acquire VMO for IO buffer. Can be called multiple times. Each call
    /// returns a new handle to the VMO.
    GetBuffer() -> (zx.status res, handle<vmo>? vmo);

    /// Attempt to read up to count bytes into IO buffer at specified offset.
    /// Returns `ZX_ERR_SHOULD_WAIT` if pipe device is not readable.
    Read(uint64 count, uint64 offset) -> (zx.status res, uint64 actual);

    /// Writes up to count bytes from the IO buffer at specified offset.
    /// Returns `ZX_ERR_SHOULD_WAIT` if pipe device is not writable.
    Write(uint64 count, uint64 offset) -> (zx.status res, uint64 actual);

    /// Writes count bytes from the IO buffer at specified write
    /// offset. Blocks if pipe device is not writable. Subsequently reads
    /// read_count bytes into the IO buffer at specified read offset.
    /// Returns `ZX_ERR_SHOULD_WAIT` if pipe device is not readable.
    Call(uint64 count, uint64 offset, uint64 read_count, uint64 read_offset)
        -> (zx.status res, uint64 actual);
};