// Copyright 2019 The Fuchsia Authors. All rights reserved.
// Use of this source code is governed by a BSD-style license that can be
// found in the LICENSE file.

library fuchsia.ui.brightness;

/// A normalized relative brightness adjustment in the range
/// 0.0 (off/minimum) to 1.0 (maximum).
using brightness = float32;

/// Control provides an interface to manage the brightness component.
[Discoverable]
protocol Control {
    /// Turns the auto-brightness mode on.
    /// SetManualBrightness will turn it off.
    SetAutoBrightness();

    /// Requests the current auto-brightness mode.
    /// This call implements the Hanging Get protocol.
    WatchAutoBrightness() -> (bool enabled);

    /// Turns auto-brightness mode off.
    /// Used by e.g. Settings to set manual brightness using a slider
    /// Value is in the range 0.0 to 1.0 representing min to max and
    /// will be clamped if out of range.
    SetManualBrightness(brightness value);

    /// Gets the current brightness in the range 0.0 to 1.0.
    /// This result is valid for both manual and auto-brightness modes
    /// and is typically used to show the current brightness on a slider.
    /// This call implements the Hanging Get protocol.
    WatchCurrentBrightness() -> (brightness value);

    /// Sets the brightness adjustment.
    /// This will change the brightness curve by the factor of the adjustment.
    /// The adjustment is in the range of -1.0 to 1.0.
    SetAutoBrightnessAdjustment(float32 adjustment);

    /// Gets the current auto brightness adjustment.
    /// This call implements the Hanging Get protocol.
    WatchAutoBrightnessAdjustment() -> (float32 adjustment);

    /// Sets the brightness curve as a set of points.
    /// This will override the built-in brightness curve.
    /// The default brightness curve will be used if the table is empty.
    /// The connection will be closed if table errors are detected.
    SetBrightnessTable(BrightnessTable table);
};

/// A tuple representing a point on the auto-brightness curve
/// Ambient_lux and nits must be positive values.
struct BrightnessPoint {
    float32 ambient_lux;
    float32 display_nits;
};

/// A set of points defining the auto-brightness curve.
/// The ambient_lux values must be monotonically increasing.
struct BrightnessTable {
    vector<BrightnessPoint>:50 points;
};