Device files

The userspace CMA uses a single device file regardless of the number of adapters or ports present.

To create the appropriate character device file automatically with udev, a rule like

KERNEL="rdma_cm", NAME="infiniband/%k", MODE="0666"

can be used. This will create the device node named

/dev/infiniband/rdma_cm

or you can create it manually

mknod /dev/infiniband/rdma_cm c 231 255

Common issues

Using multiple interfaces : The librdmacm does support multiple interfaces. To make use of multiple interfaces, however, you need to instruct linux to only send ARP replies on the interface targeted in the ARP request. This can be done using a command similar to the following:

	sysctl -w net.ipv4.conf.all.arp_ignore=2

Without this change, it's possible for linux to resopnd to ARP
requests on a different interface (IP address) than the IP
address carried in the ARP request.  This causes the RDMA stack
to incorrectly map the remote IP address to the wrong RDMA
device.

Using loopback : The librdmacm relies on ARP to resolve IP address to RDMA addresses. To support loopback connections between different ports on the same system, ARP must be enabled for local resolution:

	sysctl net.ipv4.conf.all.accept_local=1

Without this setting, loopback connections may timeout
during address resolution.