Intel LPC Device Binding
========================

The device tree node which describes the operation of the Intel Low Pin
Count device is as follows:

Required properties :
- compatible = "intel,lpc"
- intel,alt-gp-smi-enable : Enable SMI sources. This cell is written to the
    ALT_GP_SMI_EN register
- intel,gen-dec : Specifies the values for the gen-dec registers. Up to four
   cell pairs can be provided - the first of each pair is the base address and
   the second is the size. These are written into the GENx_DEC registers of
   the LPC device
- intel,gpi-routing : Specifies the GPI routing. There are 16 cells, valid
   values are:
     0 No effect (default)
     1 SMI# (if corresponding ALT_GPI_SMI_EN bit is also set)
     2 SCI (if corresponding GPIO_EN bit is also set)
- intel,pirq-routing : Speciffies the routing IRQ number for each of PIRQA-H,
   one cell for each.
     0x00 - 0000 = Reserved
     0x01 - 0001 = Reserved
     0x02 - 0010 = Reserved
     0x03 - 0011 = IRQ3
     0x04 - 0100 = IRQ4
     0x05 - 0101 = IRQ5
     0x06 - 0110 = IRQ6
     0x07 - 0111 = IRQ7
     0x08 - 1000 = Reserved
     0x09 - 1001 = IRQ9
     0x0A - 1010 = IRQ10
     0x0B - 1011 = IRQ11
     0x0C - 1100 = IRQ12
     0x0D - 1101 = Reserved
     0x0E - 1110 = IRQ14
     0x0F - 1111 = IRQ15
     PIRQ[n]_ROUT[7] - PIRQ Routing Control
     0x80 - The PIRQ is not routed.


Example
-------

lpc {
	compatible = "intel,lpc";
	#address-cells = <1>;
	#size-cells = <1>;
	intel,gen-dec = <0x800 0xfc 0x900 0xfc>;

	intel,pirq-routing = <0x8b 0x8a 0x8b 0x8b
				0x80 0x80 0x80 0x80>;
	/*
		* GPI routing
		* 0 No effect (default)
		* 1 SMI# (if corresponding ALT_GPI_SMI_EN bit is
		*	also set)
		* 2 SCI (if corresponding GPIO_EN bit is also set)
		*/
	intel,gpi-routing = <0 0 0 0 0 0 0 2
				1 0 0 0 0 0 0 0>;
	/* Enable EC SMI source */
	intel,alt-gp-smi-enable = <0x0100>;
};