
/*
 * board/amlogic/txl_skt_v1/firmware/scp_task/pwr_ctrl.c
 *
 * Copyright (C) 2015 Amlogic, Inc. All rights reserved.
 *
 * This program is free software; you can redistribute it and/or modify
 * it under the terms of the GNU General Public License as published by
 * the Free Software Foundation; either version 2 of the License, or
 * (at your option) any later version.
 *
 * This program is distributed in the hope that it will be useful, but WITHOUT
 * ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or
 * FITNESS FOR A PARTICULAR PURPOSE.  See the GNU General Public License for
 * more details.
 *
 * You should have received a copy of the GNU General Public License along
 * with this program; if not, write to the Free Software Foundation, Inc.,
 * 51 Franklin Street, Fifth Floor, Boston, MA  02110-1301, USA.
*/

#include <gpio.h>
#include "pwm_ctrl.h"

#ifdef CONFIG_CEC_WAKEUP
#include <cec_tx_reg.h>
#endif
#define ON 1
#define OFF 0

#define ARRAY_SIZE(x) (sizeof(x) / sizeof((x)[0]))

static void set_vddee_voltage(unsigned int target_voltage)
{
	unsigned int to, pwm_size = 0;
	static int (*pwm_voltage_ee)[2];

	/* BOOT_9 = H use PWM_CFG0(0.67v-0.97v), =L use PWM_CFG1(0.69v-0.89v) */
	/*set BOOT_9 input mode*/
	writel((readl(PREG_PAD_GPIO0_EN_N) | 0x200), PREG_PAD_GPIO0_EN_N);
	if (((readl(PREG_PAD_GPIO0_EN_N) & 0x200 ) == 0x200) &&
			((readl(PREG_PAD_GPIO0_I) & 0x200 ) == 0x0)) {
		uart_puts("use vddee new table!");
		uart_puts("\n");
		pwm_voltage_ee = pwm_voltage_table_ee_new;
		pwm_size = ARRAY_SIZE(pwm_voltage_table_ee_new);
	} else {
		uart_puts("use vddee table!");
		uart_puts("\n");
		pwm_voltage_ee = pwm_voltage_table_ee;
		pwm_size = ARRAY_SIZE(pwm_voltage_table_ee);
	}

	for (to = 0; to < pwm_size; to++) {
		if (pwm_voltage_ee[to][1] >= target_voltage) {
			break;
		}
	}

	if (to >= pwm_size) {
		to = pwm_size - 1;
	}

	writel(*(*(pwm_voltage_ee + to)), AO_PWM_PWM_B);
}

static void power_off_at_24M(unsigned int suspend_from)
{
	return;
}

static void power_on_at_24M(unsigned int suspend_from)
{
	return;
	set_vddee_voltage(CONFIG_VDDEE_INIT_VOLTAGE);
}

void get_wakeup_source(void *response, unsigned int suspend_from)
{
	struct wakeup_info *p = (struct wakeup_info *)response;
	struct wakeup_gpio_info *gpio;
	unsigned val;
	unsigned i = 0;

	p->status = RESPONSE_OK;
	val = (POWER_KEY_WAKEUP_SRC | AUTO_WAKEUP_SRC | REMOTE_WAKEUP_SRC |
	      BT_WAKEUP_SRC | CECB_WAKEUP_SRC);
	p->sources = val;
	p->gpio_info_count = i;

	/*bt wake host*/
	gpio = &(p->gpio_info[i]);
	gpio->wakeup_id = BT_WAKEUP_SRC;
	gpio->gpio_in_idx = GPIOX_18;
	gpio->gpio_in_ao = 0;
	gpio->gpio_out_idx = -1;
	gpio->gpio_out_ao = -1;
	gpio->irq = IRQ_GPIO0_NUM;
	gpio->trig_type = GPIO_IRQ_FALLING_EDGE;
	p->gpio_info_count = ++i;

}
extern void __switch_idle_task(void);

static unsigned int detect_key(unsigned int suspend_from)
{
	int exit_reason = 0;
	unsigned *irq = (unsigned *)WAKEUP_SRC_IRQ_ADDR_BASE;
	init_remote();
#ifdef CONFIG_CEC_WAKEUP
		if (hdmi_cec_func_config & 0x1) {
			remote_cec_hw_reset();
			cec_node_init();
		}
#endif

	do {
		#ifdef CONFIG_CEC_WAKEUP
		if (irq[IRQ_AO_CECB] == IRQ_AO_CEC2_NUM) {
			irq[IRQ_AO_CECB] = 0xFFFFFFFF;
			if (cec_power_on_check())
				exit_reason = CEC_WAKEUP;
		}
		#endif
		if (irq[IRQ_AO_IR_DEC] == IRQ_AO_IR_DEC_NUM) {
			irq[IRQ_AO_IR_DEC] = 0xFFFFFFFF;
			if (remote_detect_key())
				exit_reason = REMOTE_WAKEUP;
		}

		if (irq[IRQ_VRTC] == IRQ_VRTC_NUM) {
			irq[IRQ_VRTC] = 0xFFFFFFFF;
			exit_reason = RTC_WAKEUP;
		}

		if (irq[IRQ_GPIO0] == IRQ_GPIO0_NUM) {
			irq[IRQ_GPIO0] = 0xFFFFFFFF;
			if (!(readl(PREG_PAD_GPIO2_I) & (0x01 << 18))
					&& (readl(PREG_PAD_GPIO2_O) & (0x01 << 17))
					&& !(readl(PREG_PAD_GPIO2_EN_N) & (0x01 << 17)))
				exit_reason = BT_WAKEUP;
		}

		if (irq[IRQ_ETH_PTM] == IRQ_ETH_PMT_NUM) {
			irq[IRQ_ETH_PTM]= 0xFFFFFFFF;
			exit_reason = ETH_PMT_WAKEUP;
		}

		if (exit_reason)
			break;
		else
			__switch_idle_task();
	} while (1);

	return exit_reason;
}

static void pwr_op_init(struct pwr_op *pwr_op)
{
	pwr_op->power_off_at_24M = power_off_at_24M;
	pwr_op->power_on_at_24M = power_on_at_24M;
	pwr_op->detect_key = detect_key;
	pwr_op->get_wakeup_source = get_wakeup_source;
}