blob: 0556e4b3509e6b1e8b50d69bb98add96c1fef4f0 [file] [log] [blame]
menu "Panasonic UniPhier platform"
depends on ARCH_UNIPHIER
config SYS_SOC
default "uniphier"
config SYS_CONFIG_NAME
default "uniphier"
config UNIPHIER_SMP
bool
choice
prompt "UniPhier SoC select"
config MACH_PH1_PRO4
bool "PH1-Pro4"
select UNIPHIER_SMP
config MACH_PH1_LD4
bool "PH1-LD4"
config MACH_PH1_SLD8
bool "PH1-sLD8"
endchoice
choice
prompt "UniPhier Support Card select"
optional
config PFC_MICRO_SUPPORT_CARD
bool "Support card with PFC CPLD"
help
This option provides support for the expansion board with PFC
original address mapping.
Say Y to use the on-board UART, Ether, LED devices.
config DCC_MICRO_SUPPORT_CARD
bool "Support card with DCC CPLD"
help
This option provides support for the expansion board with DCC-
arranged address mapping that is compatible with legacy UniPhier
reference boards.
Say Y to use the on-board UART, Ether, LED devices.
endchoice
config CMD_PINMON
bool "Enable boot mode pins monitor command"
depends on !SPL_BUILD
default y
help
The command "pinmon" shows the state of the boot mode pins.
The boot mode pins are latched when the system reset is deasserted
and determine which device the system should load a boot image from.
config SOC_INIT
bool
default SPL_BUILD
config DRAM_INIT
bool
default SPL_BUILD
config CMD_DDRPHY_DUMP
bool "Enable dump command of DDR PHY parameters"
depends on !SPL_BUILD
help
The command "ddrphy" shows the resulting parameters of DDR PHY
training; it is useful for the evaluation of DDR PHY training.
choice
prompt "DDR3 Frequency select"
depends on DRAM_INIT
config DDR_FREQ_1600
bool "DDR3 1600"
depends on MACH_PH1_PRO4 || MACH_PH1_LD4
config DDR_FREQ_1333
bool "DDR3 1333"
depends on MACH_PH1_LD4 || MACH_PH1_SLD8
endchoice
config DDR_FREQ
int
default 1333 if DDR_FREQ_1333
default 1600 if DDR_FREQ_1600
endmenu