blob: 4d59480c197f35439c1c8c4327d5ee74b636e28c [file] [log] [blame]
if ARCH_STM32MP
config SPL
select SPL_BOARD_INIT
select SPL_CLK
select SPL_DM
select SPL_DM_SEQ_ALIAS
select SPL_FRAMEWORK
select SPL_GPIO_SUPPORT
select SPL_LIBCOMMON_SUPPORT
select SPL_LIBGENERIC_SUPPORT
select SPL_OF_CONTROL
select SPL_OF_TRANSLATE
select SPL_PINCTRL
select SPL_REGMAP
select SPL_RESET_SUPPORT
select SPL_SERIAL_SUPPORT
select SPL_SYSCON
select SPL_DRIVERS_MISC_SUPPORT
imply SPL_LIBDISK_SUPPORT
config SYS_SOC
default "stm32mp"
config TARGET_STM32MP1
bool "Support stm32mp1xx"
select CPU_V7
select PINCTRL_STM32
select STM32_RESET
select SYS_ARCH_TIMER
select SYSRESET_SYSCON
help
target STMicroelectronics SOC STM32MP1 family
STMicroelectronics MPU with core ARMv7
config SYS_TEXT_BASE
prompt "U-Boot base address"
default 0xC0100000
help
configure the U-Boot base address
when DDR driver is used:
DDR + 1MB (0xC0100000)
config SYS_MMCSD_RAW_MODE_U_BOOT_PARTITION_MMC2
hex "Partition on MMC2 to use to load U-Boot from"
depends on SYS_MMCSD_RAW_MODE_U_BOOT_USE_PARTITION
default 1
help
Partition on the second MMC to load U-Boot from when the MMC is being
used in raw mode
source "board/st/stm32mp1/Kconfig"
endif