blob: 683fd53b6af859ebdbae84322b3879dd53926f8c [file] [log] [blame] [edit]
// SPDX-License-Identifier: GPL-2.0+
/*
* Copyright (C) 1999 Magnus Damm <kieraypc01.p.y.kie.era.ericsson.se>
*
* (C) Copyright 2000
* Wolfgang Denk, DENX Software Engineering, wd@denx.de.
*/
#include <common.h>
/*
* The exception table consists of pairs of addresses: the first is the
* address of an instruction that is allowed to fault, and the second is
* the address at which the program should continue. No registers are
* modified, so it is entirely up to the continuation code to figure out
* what to do.
*
* All the routines below use bits of fixup code that are out of line
* with the main instruction path. This means when everything is well,
* we don't even have to jump over them. Further, they do not intrude
* on our cache or tlb entries.
*/
struct exception_table_entry
{
unsigned long insn, fixup;
};
extern const struct exception_table_entry __start___ex_table[];
extern const struct exception_table_entry __stop___ex_table[];
static inline unsigned long
search_one_table(const struct exception_table_entry *first,
const struct exception_table_entry *last,
unsigned long value)
{
long diff;
while (first <= last) {
diff = first->insn - value;
if (diff == 0)
return first->fixup;
first++;
}
return 0;
}
unsigned long
search_exception_table(unsigned long addr)
{
unsigned long ret;
/* There is only the kernel to search. */
ret = search_one_table(__start___ex_table, __stop___ex_table-1, addr);
/* if the serial port does not hang in exception, printf can be used */
#if !defined(CONFIG_SYS_SERIAL_HANG_IN_EXCEPTION)
debug("Bus Fault @ 0x%08lx, fixup 0x%08lx\n", addr, ret);
#endif
if (ret) return ret;
return 0;
}