| U-Boot for Wandboard |
| -------------------- |
| |
| This file contains information for the port of U-Boot to the Wandboard. |
| |
| Wandboard is a development board that has three variants based on the following |
| SoCs: mx6 quad, mx6 dual lite and mx6 solo. |
| |
| For more details about Wandboard, please refer to: |
| http://www.wandboard.org/ |
| |
| Building U-boot for Wandboard |
| ----------------------------- |
| |
| To build U-Boot for the Wandboard Dual Lite version: |
| |
| $ make wandboard_dl_config |
| $ make |
| |
| To build U-Boot for the Wandboard Solo version: |
| |
| $ make wandboard_solo_config |
| $ make |
| |
| To build U-Boot for the Wandboard Quad version: |
| |
| $ make wandboard_quad_config |
| $ make |
| |
| Flashing U-boot into the SD card |
| -------------------------------- |
| |
| - After the 'make' command completes, the generated 'u-boot.imx' binary must be |
| flashed into the SD card; |
| |
| $ sudo dd if=u-boot.imx of=/dev/mmcblk0 bs=512 seek=2; sync |
| |
| (Note - the SD card node may vary, so adjust this as needed). |
| |
| - Insert the SD card into the slot located in the bottom of the board (same side |
| as the mx6 processor) |
| |
| - Connect the serial cable to the host PC |
| |
| - Power up the board and U-boot messages will appear in the serial console. |
