arm/km: add support for portl2 board
This adds support for the keymile Kirkwood BEC portl2 board. This board
relies on the km_arm (km_kirkwood) BEC.
The egiga driver is configured for a 100M full-duplex, A/N off connnection
to the backplane. This board has always ethernet present, because it is
connected to the marvell switch similar to mgcoge3un. The reset_phy
functionality is also the same to mgcoge3un.
Signed-off-by: Valentin Longchamp <valentin.longchamp@keymile.com>
Signed-off-by: Holger Brunck <holger.brunck@keymile.com>
cc: Prafulla Wadaskar <prafulla@marvell.com>
cc: Heiko Schocher <hs@denx.de>
diff --git a/board/keymile/km_arm/km_arm.c b/board/keymile/km_arm/km_arm.c
index ed6ede3..5da856f 100644
--- a/board/keymile/km_arm/km_arm.c
+++ b/board/keymile/km_arm/km_arm.c
@@ -130,10 +130,12 @@
return 1;
return 0;
}
+#endif
+#if (defined(CONFIG_MGCOGE3UN)|defined(CONFIG_PORTL2))
/*
- * mgcoge3un has always ethernet present. Its connected to the 6061 switch
- * and provides ICNev and piggy4 connections.
+ * These two boards have always ethernet present. Its connected to the mv
+ * switch.
*/
int ethernet_present(void)
{
@@ -335,7 +337,7 @@
}
}
-#if defined(CONFIG_MGCOGE3UN)
+#if (defined(CONFIG_MGCOGE3UN)|defined(CONFIG_PORTL2))
#define PHY_LED_SEL 0x18
#define PHY_LED0_LINK (0x5)
