Command usage cleanup
Remove command name from all command "usage" fields and update
common/command.c to display "name - usage" instead of
just "usage". Also remove newlines from command usage fields.
Signed-off-by: Peter Tyser <ptyser@xes-inc.com>
diff --git a/common/cmd_load.c b/common/cmd_load.c
index 350d7a3..88fba88 100644
--- a/common/cmd_load.c
+++ b/common/cmd_load.c
@@ -1045,7 +1045,7 @@
#ifdef CONFIG_SYS_LOADS_BAUD_CHANGE
U_BOOT_CMD(
loads, 3, 0, do_load_serial,
- "loads - load S-Record file over serial line\n",
+ "load S-Record file over serial line",
"[ off ] [ baud ]\n"
" - load S-Record file over serial line"
" with offset 'off' and baudrate 'baud'\n"
@@ -1054,7 +1054,7 @@
#else /* ! CONFIG_SYS_LOADS_BAUD_CHANGE */
U_BOOT_CMD(
loads, 2, 0, do_load_serial,
- "loads - load S-Record file over serial line\n",
+ "load S-Record file over serial line",
"[ off ]\n"
" - load S-Record file over serial line with offset 'off'\n"
);
@@ -1069,7 +1069,7 @@
#ifdef CONFIG_SYS_LOADS_BAUD_CHANGE
U_BOOT_CMD(
saves, 4, 0, do_save_serial,
- "saves - save S-Record file over serial line\n",
+ "save S-Record file over serial line",
"[ off ] [size] [ baud ]\n"
" - save S-Record file over serial line"
" with offset 'off', size 'size' and baudrate 'baud'\n"
@@ -1077,7 +1077,7 @@
#else /* ! CONFIG_SYS_LOADS_BAUD_CHANGE */
U_BOOT_CMD(
saves, 3, 0, do_save_serial,
- "saves - save S-Record file over serial line\n",
+ "save S-Record file over serial line",
"[ off ] [size]\n"
" - save S-Record file over serial line with offset 'off' and size 'size'\n"
);
@@ -1089,7 +1089,7 @@
#if defined(CONFIG_CMD_LOADB)
U_BOOT_CMD(
loadb, 3, 0, do_load_serial_bin,
- "loadb - load binary file over serial line (kermit mode)\n",
+ "load binary file over serial line (kermit mode)",
"[ off ] [ baud ]\n"
" - load binary file over serial line"
" with offset 'off' and baudrate 'baud'\n"
@@ -1097,7 +1097,7 @@
U_BOOT_CMD(
loady, 3, 0, do_load_serial_bin,
- "loady - load binary file over serial line (ymodem mode)\n",
+ "load binary file over serial line (ymodem mode)",
"[ off ] [ baud ]\n"
" - load binary file over serial line"
" with offset 'off' and baudrate 'baud'\n"
@@ -1129,7 +1129,7 @@
U_BOOT_CMD(
hwflow, 2, 0, do_hwflow,
- "hwflow - turn the harwdare flow control on/off\n",
+ "turn the harwdare flow control on/off",
"[on|off]\n - change RTS/CTS hardware flow control over serial line\n"
);
