(re)enabled scsi commands do_scsi() and do_scsiboot()
Patch by Denis Peter, 06 Dec 2004
diff --git a/common/cmd_scsi.c b/common/cmd_scsi.c
index 7ee9d8e..ec53790 100644
--- a/common/cmd_scsi.c
+++ b/common/cmd_scsi.c
@@ -585,4 +585,23 @@
pccb->msgout[0]=SCSI_IDENTIFY; /* NOT USED */
}
+
+U_BOOT_CMD(
+ scsi, 5, 1, do_scsi,
+ "scsi - SCSI sub-system\n",
+ "reset - reset SCSI controller\n"
+ "scsi info - show available SCSI devices\n"
+ "scsi scan - (re-)scan SCSI bus\n"
+ "scsi device [dev] - show or set current device\n"
+ "scsi part [dev] - print partition table of one or all SCSI devices\n"
+ "scsi read addr blk# cnt - read `cnt' blocks starting at block `blk#'\n"
+ " to memory address `addr'\n"
+);
+
+U_BOOT_CMD(
+ scsiboot, 3, 1, do_scsiboot,
+ "scsiboot- boot from SCSI device\n",
+ "loadAddr dev:part\n"
+);
+
#endif /* #if (CONFIG_COMMANDS & CFG_CMD_SCSI) */
