serial: zynq: Move serial registration from serial_initialize()
Move the registration of zynq_serialN_device ports from default
serial_initialize() into driver specific function called from
serial_initialize(). This slims down the serial_initialize() call
to a bare tracker of all possible serial port registration routines
in U-Boot.
The newly implemented zynq_serial_initialize() function, which is
implemented inside of the serial_zynq driver allows encapsulation
of zynq_serialN_device within the serial_zynq driver itself.
Also, remove the exports of zynq_serialN_device from include/serial.h
as they are no longer needed. This is simply because the implementation of
default_serial_console() is wrapped into the serial_zynq driver and
the default console is picked by CONFIG_SERIAL<N> macro in config file.
Signed-off-by: Tom Rini <trini@ti.com>
diff --git a/common/serial.c b/common/serial.c
index bed907e..a1bef16 100644
--- a/common/serial.c
+++ b/common/serial.c
@@ -44,6 +44,7 @@
serial_initfunc(pxa_serial_initialize);
serial_initfunc(s3c24xx_serial_initialize);
serial_initfunc(s5p_serial_initialize);
+serial_initfunc(zynq_serial_initalize);
void serial_register(struct serial_device *dev)
{
@@ -111,14 +112,7 @@
serial_register(&uartlite_serial3_device);
# endif /* XILINX_UARTLITE_BASEADDR3 */
#endif /* CONFIG_XILINX_UARTLITE */
-#if defined(CONFIG_ZYNQ_SERIAL)
-# ifdef CONFIG_ZYNQ_SERIAL_BASEADDR0
- serial_register(&uart_zynq_serial0_device);
-# endif
-# ifdef CONFIG_ZYNQ_SERIAL_BASEADDR1
- serial_register(&uart_zynq_serial1_device);
-# endif
-#endif
+ zynq_serial_initalize();
serial_assign(default_serial_console()->name);
}
