rename CFG_ macros to CONFIG_SYS
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
diff --git a/cpu/ppc4xx/44x_spd_ddr.c b/cpu/ppc4xx/44x_spd_ddr.c
index 9efcede..153391e 100644
--- a/cpu/ppc4xx/44x_spd_ddr.c
+++ b/cpu/ppc4xx/44x_spd_ddr.c
@@ -62,12 +62,12 @@
/*
* Set default values
*/
-#ifndef CFG_I2C_SPEED
-#define CFG_I2C_SPEED 50000
+#ifndef CONFIG_SYS_I2C_SPEED
+#define CONFIG_SYS_I2C_SPEED 50000
#endif
-#ifndef CFG_I2C_SLAVE
-#define CFG_I2C_SLAVE 0xFE
+#ifndef CONFIG_SYS_I2C_SLAVE
+#define CONFIG_SYS_I2C_SLAVE 0xFE
#endif
#define ONE_BILLION 1000000000
@@ -119,7 +119,7 @@
typedef struct bank_param BANKPARMS;
-#ifdef CFG_SIMULATE_SPD_EEPROM
+#ifdef CONFIG_SYS_SIMULATE_SPD_EEPROM
extern const unsigned char cfg_simulate_spd_eeprom[128];
#endif
@@ -174,7 +174,7 @@
* Make sure I2C controller is initialized
* before continuing.
*/
- i2c_init(CFG_I2C_SPEED, CFG_I2C_SLAVE);
+ i2c_init(CONFIG_SYS_I2C_SPEED, CONFIG_SYS_I2C_SLAVE);
/*
* Read the SPD information using I2C interface. Check to see if the
@@ -265,7 +265,7 @@
/*
* If ecc is enabled, initialize the parity bits.
*/
- ecc_init(CFG_SDRAM_BASE, total_size);
+ ecc_init(CONFIG_SYS_SDRAM_BASE, total_size);
#endif
return total_size;
@@ -275,14 +275,14 @@
{
unsigned char data[2];
-#ifdef CFG_SIMULATE_SPD_EEPROM
- if (chip == CFG_SIMULATE_SPD_EEPROM) {
+#ifdef CONFIG_SYS_SIMULATE_SPD_EEPROM
+ if (chip == CONFIG_SYS_SIMULATE_SPD_EEPROM) {
/*
* Onboard spd eeprom requested -> simulate values
*/
return cfg_simulate_spd_eeprom[addr];
}
-#endif /* CFG_SIMULATE_SPD_EEPROM */
+#endif /* CONFIG_SYS_SIMULATE_SPD_EEPROM */
if (i2c_probe(chip) == 0) {
if (i2c_read(chip, addr, 1, data, 1) == 0) {
@@ -1120,7 +1120,7 @@
/*
* reset the bank_base address
*/
- bank_base_addr = CFG_SDRAM_BASE;
+ bank_base_addr = CONFIG_SYS_SDRAM_BASE;
for (dimm_num = 0; dimm_num < num_dimm_banks; dimm_num++) {
if (dimm_populated[dimm_num] == TRUE) {
