fsl_pci: Add support for FSL PCIe controllers v2.x
FSL PCIe controller v2.1:
- New MSI inbound window
- Same Inbound windows address as PCIe controller v1.x
Added new pit_t member(pmit) to struct ccsr_pci for MSI inbound window
FSL PCIe controller v2.2 and v2.3:
- Different addresses for PCIe inbound window 3,2,1
- Exposed PCIe inbound window 0
- New PCIe interrupt status register
Added new Interrupt Status register to struct ccsr_pci & updated pit_t array
size to reflect the 4 inbound windows.
To maintain backward compatiblilty, on V2.2 or greater controllers we
start with inbound window 1 and leave inbound 0 with its default value
(which maps to CCSRBAR).
Signed-off-by: Prabhakar Kushwaha <prabhakar@freescale.com>
Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
diff --git a/drivers/pci/fsl_pci_init.c b/drivers/pci/fsl_pci_init.c
index dc34bd6..ab461b4 100644
--- a/drivers/pci/fsl_pci_init.c
+++ b/drivers/pci/fsl_pci_init.c
@@ -1,5 +1,5 @@
/*
- * Copyright 2007-2010 Freescale Semiconductor, Inc.
+ * Copyright 2007-2011 Freescale Semiconductor, Inc.
*
* This program is free software; you can redistribute it and/or modify it
* under the terms of the GNU General Public License as published by the Free
@@ -223,6 +223,7 @@
u32 cfg_data = (u32)&((ccsr_fsl_pci_t *)pci_info->regs)->cfg_data;
u16 temp16;
u32 temp32;
+ u32 block_rev;
int enabled, r, inbound = 0;
u16 ltssm;
u8 temp8, pcie_cap;
@@ -232,13 +233,20 @@
/* Initialize ATMU registers based on hose regions and flags */
volatile pot_t *po = &pci->pot[1]; /* skip 0 */
- volatile pit_t *pi = &pci->pit[2]; /* ranges from: 3 to 1 */
+ volatile pit_t *pi;
u64 out_hi = 0, out_lo = -1ULL;
u32 pcicsrbar, pcicsrbar_sz;
pci_setup_indirect(hose, cfg_addr, cfg_data);
+ block_rev = in_be32(&pci->block_rev1);
+ if (PEX_IP_BLK_REV_2_2 <= block_rev) {
+ pi = &pci->pit[2]; /* 0xDC0 */
+ } else {
+ pi = &pci->pit[3]; /* 0xDE0 */
+ }
+
/* Handle setup of outbound windows first */
for (r = 0; r < hose->region_count; r++) {
unsigned long flags = hose->regions[r].flags;
