da850: fix the channel number for EMAC teardown init

TX and RX channel numbers programmed as '1' during EMAC
teardown initialization is wrong. This patch fixes the
same by setting channel number to '0' which is used by U-boot.

Signed-off-by: Sugumar Natarajan <sugumar@ti.com>
Signed-off-by: Nagabhushana Netagunte <nagabhushana.netagunte@ti.com>
Signed-off-by: Sandeep Paulraj <s-paulraj@ti.com>

drivers/net/davinci_emac.c

diff --git a/drivers/net/davinci_emac.c b/drivers/net/davinci_emac.c
index 66c0d13..c0b8929 100644
--- a/drivers/net/davinci_emac.c
+++ b/drivers/net/davinci_emac.c
@@ -457,7 +457,7 @@
 
 	if (ch == EMAC_CH_TX) {
 		/* Init TX channel teardown */
-		writel(1, &adap_emac->TXTEARDOWN);
+		writel(0, &adap_emac->TXTEARDOWN);
 		do {
 			/*
 			 * Wait here for Tx teardown completion interrupt to
@@ -476,7 +476,7 @@
 		writel(0, &adap_emac->TX0HDP);
 	} else {
 		/* Init RX channel teardown */
-		writel(1, &adap_emac->RXTEARDOWN);
+		writel(0, &adap_emac->RXTEARDOWN);
 		do {
 			/*
 			 * Wait here for Rx teardown completion interrupt to