| /* |
| * Copyright (C) 2003 Arabella Software Ltd. |
| * Yuli Barcohen <yuli@arabellasw.com> |
| * |
| * Serial Presence Detect (SPD) EEPROM format according to the |
| * Intel's PC SDRAM Serial Presence Detect (SPD) Specification, |
| * revision 1.2B, November 1999 |
| * |
| * This program is free software; you can redistribute it and/or |
| * modify it under the terms of the GNU General Public License as |
| * published by the Free Software Foundation; either version 2 of the |
| * License, or (at your option) any later version. |
| * |
| * This program is distributed in the hope that it will be useful, but |
| * WITHOUT ANY WARRANTY; without even the implied warranty of |
| * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the GNU |
| * General Public License for more details. |
| * |
| * You should have received a copy of the GNU General Public License |
| * along with this program; if not, write to the Free Software |
| * Foundation, Inc., 675 Mass Ave, Cambridge, MA 02139, USA. |
| */ |
| |
| #ifndef _SPD_H_ |
| #define _SPD_H_ |
| |
| typedef struct spd_eeprom_s { |
| unsigned char info_size; /* 0 # bytes written into serial memory */ |
| unsigned char chip_size; /* 1 Total # bytes of SPD memory device */ |
| unsigned char mem_type; /* 2 Fundamental memory type */ |
| unsigned char nrow_addr; /* 3 # of Row Addresses on this assembly */ |
| unsigned char ncol_addr; /* 4 # of Column Addrs on this assembly */ |
| unsigned char nrows; /* 5 # of Module Rows on this assembly */ |
| unsigned char dataw_lsb; /* 6 Data Width of this assembly */ |
| unsigned char dataw_msb; /* 7 ... Data Width continuation */ |
| unsigned char voltage; /* 8 Voltage intf std of this assembly */ |
| unsigned char clk_cycle; /* 9 SDRAM Cycle time at CL=X */ |
| unsigned char clk_access; /* 10 SDRAM Access from Clock at CL=X */ |
| unsigned char config; /* 11 DIMM Configuration type */ |
| unsigned char refresh; /* 12 Refresh Rate/Type */ |
| unsigned char primw; /* 13 Primary SDRAM Width */ |
| unsigned char ecw; /* 14 Error Checking SDRAM width */ |
| unsigned char min_delay; /* 15 for Back to Back Random Address */ |
| unsigned char burstl; /* 16 Burst Lengths Supported */ |
| unsigned char nbanks; /* 17 # of Banks on Each SDRAM Device */ |
| unsigned char cas_lat; /* 18 CAS# Latencies Supported */ |
| unsigned char cs_lat; /* 19 CS# Latency */ |
| unsigned char write_lat; /* 20 Write Latency (aka Write Recovery) */ |
| unsigned char mod_attr; /* 21 SDRAM Module Attributes */ |
| unsigned char dev_attr; /* 22 SDRAM Device Attributes */ |
| unsigned char clk_cycle2; /* 23 Min SDRAM Cycle time at CL=X-1 */ |
| unsigned char clk_access2; /* 24 SDRAM Access from Clock at CL=X-1 */ |
| unsigned char clk_cycle3; /* 25 Min SDRAM Cycle time at CL=X-2 */ |
| unsigned char clk_access3; /* 26 Max Access from Clock at CL=X-2 */ |
| unsigned char trp; /* 27 Min Row Precharge Time (tRP)*/ |
| unsigned char trrd; /* 28 Min Row Active to Row Active (tRRD) */ |
| unsigned char trcd; /* 29 Min RAS to CAS Delay (tRCD) */ |
| unsigned char tras; /* 30 Minimum RAS Pulse Width (tRAS) */ |
| unsigned char row_dens; /* 31 Density of each row on module */ |
| unsigned char ca_setup; /* 32 Cmd + Addr signal input setup time */ |
| unsigned char ca_hold; /* 33 Cmd and Addr signal input hold time */ |
| unsigned char data_setup; /* 34 Data signal input setup time */ |
| unsigned char data_hold; /* 35 Data signal input hold time */ |
| unsigned char twr; /* 36 Write Recovery time tWR */ |
| unsigned char twtr; /* 37 Int write to read delay tWTR */ |
| unsigned char trtp; /* 38 Int read to precharge delay tRTP */ |
| unsigned char mem_probe; /* 39 Mem analysis probe characteristics */ |
| unsigned char trctrfc_ext; /* 40 Extensions to trc and trfc */ |
| unsigned char trc; /* 41 Min Active to Auto refresh time tRC */ |
| unsigned char trfc; /* 42 Min Auto to Active period tRFC */ |
| unsigned char tckmax; /* 43 Max device cycle time tCKmax */ |
| unsigned char tdqsq; /* 44 Max DQS to DQ skew */ |
| unsigned char tqhs; /* 45 Max Read DataHold skew tQHS */ |
| unsigned char pll_relock; /* 46 PLL Relock time */ |
| unsigned char res[15]; /* 47-xx IDD in SPD and Reserved space */ |
| unsigned char spd_rev; /* 62 SPD Data Revision Code */ |
| unsigned char cksum; /* 63 Checksum for bytes 0-62 */ |
| unsigned char mid[8]; /* 64 Mfr's JEDEC ID code per JEP-108E */ |
| unsigned char mloc; /* 72 Manufacturing Location */ |
| unsigned char mpart[18]; /* 73 Manufacturer's Part Number */ |
| unsigned char rev[2]; /* 91 Revision Code */ |
| unsigned char mdate[2]; /* 93 Manufacturing Date */ |
| unsigned char sernum[4]; /* 95 Assembly Serial Number */ |
| unsigned char mspec[27]; /* 99 Manufacturer Specific Data */ |
| |
| /* |
| * Open for Customer Use starting with byte 128. |
| */ |
| unsigned char freq; /* 128 Intel spec: frequency */ |
| unsigned char intel_cas; /* 129 Intel spec: CAS# Latency support */ |
| } spd_eeprom_t; |
| |
| |
| /* |
| * Byte 2 Fundamental Memory Types. |
| */ |
| #define SPD_MEMTYPE_FPM (0x01) |
| #define SPD_MEMTYPE_EDO (0x02) |
| #define SPD_MEMTYPE_PIPE_NIBBLE (0x03) |
| #define SPD_MEMTYPE_SDRAM (0x04) |
| #define SPD_MEMTYPE_ROM (0x05) |
| #define SPD_MEMTYPE_SGRAM (0x06) |
| #define SPD_MEMTYPE_DDR (0x07) |
| #define SPD_MEMTYPE_DDR2 (0x08) |
| |
| #endif /* _SPD_H_ */ |
