blob: 708efb8b9263bc899634f0f583e64f172274fae2 [file] [log] [blame]
/*
* arch/arm/include/asm/arch-txl/sd_emmc.h
*
* Copyright (C) 2015 Amlogic, Inc. All rights reserved.
*
* This program is free software; you can redistribute it and/or modify
* it under the terms of the GNU General Public License as published by
* the Free Software Foundation; either version 2 of the License, or
* (at your option) any later version.
*
* This program is distributed in the hope that it will be useful, but WITHOUT
* ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or
* FITNESS FOR A PARTICULAR PURPOSE. See the GNU General Public License for
* more details.
*
* You should have received a copy of the GNU General Public License along
* with this program; if not, write to the Free Software Foundation, Inc.,
* 51 Franklin Street, Fifth Floor, Boston, MA 02110-1301, USA.
*/
#ifndef __SD_EMMC_H__
#define __SD_EMMC_H__
#include "cpu_sdio.h"
#define SD_EMMC_BASE_A 0xFFE03000
#define SD_EMMC_BASE_B 0xFFE05000
#define SD_EMMC_BASE_C 0xFFE07000
#define NEWSD_IRQ_ALL 0x3fff
#define SD_EMMC_CLKSRC_24M 24000000
#define SD_EMMC_CLKSRC_DIV2 1000000000
#define NEWSD_IRQ_EN_ALL_INIT
#define NEWSD_MAX_DESC_MUN 512
#define NEWSD_BOUNCE_REQ_SIZE (512*1024)
#define MAX_BLOCK_COUNTS 256
#define SD_EMMC_CLKSRC 24000000
#define MMC_RSP_136_NUM 4
#define MAX_RESPONSE_BYTES 4
#define RESPONSE_R1_R3_R6_R7_LENGTH 6
#define RESPONSE_R2_CID_CSD_LENGTH 17
#define RESPONSE_R4_R5_NONE_LENGTH 0
#define SDIO_PORT_A 0
#define SDIO_PORT_B 1
#define SDIO_PORT_C 2
#define CARD_SD_SDIO_INIT (1<<0)
#define CARD_SD_SDIO_DETECT (1<<1)
#define CARD_SD_SDIO_PWR_PREPARE (1<<2)
#define CARD_SD_SDIO_PWR_ON (1<<3)
#define CARD_SD_SDIO_PWR_OFF (1<<4)
typedef enum _SD_Error_Status_t {
SD_NO_ERROR = 0,
SD_ERROR_OUT_OF_RANGE, //Bit 31
SD_ERROR_ADDRESS, //Bit 30
SD_ERROR_BLOCK_LEN, //Bit 29
SD_ERROR_ERASE_SEQ, //Bit 28
SD_ERROR_ERASE_PARAM, //Bit 27
SD_ERROR_WP_VIOLATION, //Bit 26
SD_ERROR_CARD_IS_LOCKED, //Bit 25
SD_ERROR_LOCK_UNLOCK_FAILED, //Bit 24
SD_ERROR_COM_CRC, //Bit 23
SD_ERROR_ILLEGAL_COMMAND, //Bit 22
SD_ERROR_CARD_ECC_FAILED, //Bit 21
SD_ERROR_CC, //Bit 20
SD_ERROR_GENERAL, //Bit 19
SD_ERROR_Reserved1, //Bit 18
SD_ERROR_Reserved2, //Bit 17
SD_ERROR_CID_CSD_OVERWRITE, //Bit 16
SD_ERROR_AKE_SEQ, //Bit 03
SD_ERROR_STATE_MISMATCH,
SD_ERROR_HEADER_MISMATCH,
SD_ERROR_DATA_CRC,
SD_ERROR_TIMEOUT,
SD_ERROR_DRIVER_FAILURE,
SD_ERROR_WRITE_PROTECTED,
SD_ERROR_NO_MEMORY,
SD_ERROR_SWITCH_FUNCTION_COMUNICATION,
SD_ERROR_NO_FUNCTION_SWITCH,
SD_ERROR_NO_CARD_INS
} SD_Error_Status_t;
typedef enum _SD_Bus_Width
{
SD_BUS_SINGLE = 1, //only DAT0
SD_BUS_WIDE = 4 //use DAT0-4
} SD_Bus_Width_t;
//LSB -> MSB, structrue for SD Card Status
typedef struct _SD_Card_Status
{
unsigned Reserved3: 2;
unsigned Reserved4: 1;
unsigned AKE_SEQ_ERROR: 1; //Error in the sequence of authentication process.
unsigned Reserved5: 1;
unsigned APP_CMD: 1; //The card will expect ACMD, or indication that the command has been interpreted as ACMD.
unsigned NotUsed: 2;
unsigned READY_FOR_DATA: 1; //Corresponds to buffer empty signalling on the bus.
unsigned CURRENT_STATE: 4; //The state of the card when receiving the command.
unsigned ERASE_RESET: 1; //An erase sequence was cleared beforem executing because an out of erase sequence command was received.
unsigned CARD_ECC_DISABLED: 1; //The command has been executed without using the internal ECC.
unsigned WP_ERASE_SKIP: 1; //Only partial address space was erased due to existing write protected blocks.
unsigned CID_CSD_OVERWRITE: 1; //Can be either one of the following errors:
unsigned Reserved1: 1;
unsigned Reserved2: 1;
unsigned ERROR: 1; //A general or an unknown error occurred during the operation.
unsigned CC_ERROR: 1; //Internal card controller error
unsigned CARD_ECC_FAILED: 1; //Card internal ECC was applied but failed to correct the data.
unsigned ILLEGAL_COMMAND: 1; //Command not legal for the card state
unsigned COM_CRC_ERROR: 1; //The CRC check of the previous command failed.
unsigned LOCK_UNLOCK_FAILED: 1; //Set when a sequence or password error has been detected in lock/ unlock card command or if there was an attempt to access a locked card
unsigned CARD_IS_LOCKED: 1; //When set, signals that the card is locked by the host
unsigned WP_VIOLATION: 1; //Attempt to program a write-protected block.
unsigned ERASE_PARAM: 1; //An invalid selection of write-blocks for erase occurred.
unsigned ERASE_SEQ_ERROR: 1; //An error in the sequence of erase commands occurred.
unsigned BLOCK_LEN_ERROR: 1; //The transferred block length is not allowed for this card, or the number of transferred bytes does not match the block length.
unsigned ADDRESS_ERROR: 1; //A misaligned address that did not match the block length was used in the command.
unsigned OUT_OF_RANGE: 1; //The command??s argument was out of the allowed range for this card.
} SD_Card_Status_t;
//structure for response
typedef struct _SD_Response_R1
{
SD_Card_Status_t card_status; //card status
} SD_Response_R1_t;
struct aml_card_sd_info
{
unsigned sd_emmc_port; //0: sdioa, 1:sdiob, 2:sdioc
unsigned sd_emmc_reg_base;
char * name;
int inited_flag;
int removed_flag;
int init_retry;
int single_blk_failed;
char* desc_buf;
struct mmc_config cfg;
struct sd_emmc_global_regs *sd_emmc_reg;
dma_addr_t desc_dma_addr;
#ifdef AML_CARD_SD_INFO_DETAILED
int (* sd_emmc_init)(unsigned port,struct aml_card_sd_info *sdio);
int (* sd_emmc_detect)(unsigned port,struct aml_card_sd_info *sdio);
void (* sd_emmc_pwr_prepare)(unsigned port,struct aml_card_sd_info *sdio);
void (* sd_emmc_pwr_on)(unsigned port,struct aml_card_sd_info *sdio);
void (* sd_emmc_pwr_off)(unsigned port,struct aml_card_sd_info *sdio);
unsigned int sdio_pwr_flag;
#else
int (* sd_emmc_init)(unsigned port);
int (* sd_emmc_detect)(unsigned port);
void (* sd_emmc_pwr_prepare)(unsigned port);
void (* sd_emmc_pwr_on)(unsigned port);
void (* sd_emmc_pwr_off)(unsigned port);
#endif
};
extern struct aml_card_sd_info * cpu_sd_emmc_get(unsigned port);
extern int cpu_sd_emmc_init(unsigned port);
extern void cpu_sd_emmc_pwr_prepare(unsigned port);
struct mmc;//mmc is struct mmc , to avoid include mmc.h , declare it
extern void sd_emmc_register(struct aml_card_sd_info *);
extern void sd_emmc_para_config(struct sd_emmc_global_regs *reg,
unsigned int clock, unsigned int port);
#endif