blob: 2b0d87752edb1fdd1d9576da51546b8ac9ea6a75 [file] [log] [blame]
/*
* arch/arm/include/asm/arch-txl/eth_setup.h
*
* Copyright (C) 2015 Amlogic, Inc. All rights reserved.
*
* This program is free software; you can redistribute it and/or modify
* it under the terms of the GNU General Public License as published by
* the Free Software Foundation; either version 2 of the License, or
* (at your option) any later version.
*
* This program is distributed in the hope that it will be useful, but WITHOUT
* ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or
* FITNESS FOR A PARTICULAR PURPOSE. See the GNU General Public License for
* more details.
*
* You should have received a copy of the GNU General Public License along
* with this program; if not, write to the Free Software Foundation, Inc.,
* 51 Franklin Street, Fifth Floor, Boston, MA 02110-1301, USA.
*/
#include <asm/arch/io.h>
/*
*board configuration interface.
* */
struct eth_clock_conf{
int enable;
int clock_50MHZ_phase;
//add ... as you need.
};
struct eth_board_socket{
char *name ;
int (*eth_clock_configure)(struct eth_clock_conf);
int (*eth_pinmux_setup)(void);
int (*eth_hw_reset)(void);
};
/*
*clock define part
*/
#define ETH_BASE (0xff3f0000)
#define ETH_PLL_CNTL CBUS_REG_ADDR(0x2050)
/* Ethernet ctrl */
#define ETH_PLL_CNTL_DIVEN (1<<0)
#define ETH_PLL_CNTL_MACSPD (1<<1)
#define ETH_PLL_CNTL_DATEND (1<<2)
#define ETH_PLL_CNTL_DESEND (1<<3)
/*
please refer following doc for detail
@AppNote-M3-ClockTrees.docx
select clk: -> CBUS_REG(0x1076)
7-sys_pll_div2
6-vid2_pll_clk
5-vid_pll_clk
4-aud_pll_clk
3-ddr_pll_clk
2-misc_pll_clk
1-sys_pll_clk
0-XTAL
clk_freq:800MHz
output_clk:50MHz
aways,maybe changed for others?
*/
#define ETH_CLKSRC_XTAL (0)
#define ETH_CLKSRC_SYS_PLL_CLK (1)
#define ETH_CLKSRC_MISC_PLL_CLK (2)
#define ETH_CLKSRC_DDR_PLL_CLK (3)
#define ETH_CLKSRC_AUD_PLL_CLK (
#define ETH_CLKSRC_VID_PLL_CLK (5)
#define ETH_CLKSRC_VID2_PLL_CLK (6)
#define ETH_CLKSRC_SYS_PLL_DIV2_CLK (7)
#define CLK_1M (1000000)
typedef union eth_aml_reg0 {
/** raw register data */
unsigned int d32;
/** register bits */
struct {
unsigned phy_intf_sel:3;
unsigned rx_clk_rmii_invert:1;
unsigned rgmii_tx_clk_src:1;
unsigned rgmii_tx_clk_phase:2;
unsigned rgmii_tx_clk_ratio:3;
unsigned phy_ref_clk_enable:1;
unsigned clk_rmii_i_invert:1;
unsigned clk_en:1;
unsigned adj_enable:1;
unsigned adj_setup:1;
unsigned adj_delay:5;
unsigned adj_skew:5;
unsigned cali_start:1;
unsigned cali_rise:1;
unsigned cali_sel:3;
unsigned rgmii_rx_reuse:1;
unsigned eth_urgent:1;
} b;
} eth_aml_reg0_t;
#define ETH_VALIDE_CLKSRC(clk,out_clk) ((clk%out_clk)==0)
int eth_clk_set(int selectclk,unsigned long clk_freq,unsigned long out_clk);