| if TARGET_APALIS_IMX6 |
| |
| config SYS_BOARD |
| default "apalis_imx6" |
| |
| config SYS_CONFIG_NAME |
| default "apalis_imx6" |
| |
| config SYS_CPU |
| default "armv7" |
| |
| config SYS_SOC |
| default "mx6" |
| |
| config SYS_VENDOR |
| default "toradex" |
| |
| config TDX_CFG_BLOCK |
| default y |
| |
| config TDX_HAVE_MMC |
| default y |
| |
| config TDX_CFG_BLOCK_DEV |
| default "0" |
| |
| config TDX_CFG_BLOCK_PART |
| default "1" |
| |
| # Toradex config block in eMMC, at the end of 1st "boot sector" |
| config TDX_CFG_BLOCK_OFFSET |
| default "-512" |
| |
| config TDX_CMD_IMX_MFGR |
| bool "Enable factory testing commands for Toradex iMX 6 modules" |
| help |
| This adds the commands |
| pf0100_otp_prog - Program the OTP fuses on the PMIC PF0100 |
| If executed on already fused modules it doesn't change any fuse setting. |
| default y |
| |
| config TDX_APALIS_IMX6_V1_0 |
| bool "Apalis iMX6 V1.0 HW" |
| help |
| Apalis iMX6 V1.0 HW has a different pinout for the UART. |
| The UARTs must be used in DCE mode, RTS/CTS are swapped and |
| thus unusable on standard carrier boards. |
| This option configures DCE mode unconditionally. Whithout this |
| option the config block stating V1.0 HW selects DCE mode, |
| otherwise the UARTs are configuered in DTE mode. |
| default n |
| |
| source "board/toradex/common/Kconfig" |
| |
| endif |
