| CONFIG_ARM=y |
| CONFIG_ARCH_ZYNQ=y |
| CONFIG_SYS_TEXT_BASE=0x4000000 |
| CONFIG_SPL=y |
| CONFIG_IDENT_STRING=" Xilinx Zynq ZC770 XM011 x16" |
| CONFIG_SPL_STACK_R_ADDR=0x200000 |
| # CONFIG_SPL_FAT_SUPPORT is not set |
| CONFIG_DEFAULT_DEVICE_TREE="zynq-zc770-xm011-x16" |
| CONFIG_DEBUG_UART=y |
| CONFIG_DISTRO_DEFAULTS=y |
| CONFIG_FIT=y |
| CONFIG_FIT_SIGNATURE=y |
| CONFIG_FIT_VERBOSE=y |
| CONFIG_IMAGE_FORMAT_LEGACY=y |
| CONFIG_BOOTCOMMAND="run $modeboot || run distro_bootcmd" |
| # CONFIG_DISPLAY_CPUINFO is not set |
| CONFIG_SPL_STACK_R=y |
| CONFIG_SPL_OS_BOOT=y |
| CONFIG_SYS_PROMPT="Zynq> " |
| # CONFIG_CMD_FLASH is not set |
| CONFIG_CMD_FPGA_LOADBP=y |
| CONFIG_CMD_FPGA_LOADFS=y |
| CONFIG_CMD_FPGA_LOADMK=y |
| CONFIG_CMD_FPGA_LOADP=y |
| CONFIG_CMD_GPIO=y |
| CONFIG_CMD_NAND_LOCK_UNLOCK=y |
| # CONFIG_CMD_SETEXPR is not set |
| # CONFIG_CMD_NET is not set |
| CONFIG_CMD_CACHE=y |
| # CONFIG_SPL_DOS_PARTITION is not set |
| # CONFIG_SPL_EFI_PARTITION is not set |
| CONFIG_SPL_DM_SEQ_ALIAS=y |
| CONFIG_BLK=y |
| CONFIG_FPGA_XILINX=y |
| CONFIG_FPGA_ZYNQPL=y |
| CONFIG_DM_GPIO=y |
| # CONFIG_MMC is not set |
| CONFIG_NAND=y |
| CONFIG_NAND_ZYNQ=y |
| CONFIG_DEBUG_UART_ZYNQ=y |
| CONFIG_DEBUG_UART_BASE=0xe0001000 |
| CONFIG_DEBUG_UART_CLOCK=50000000 |
| CONFIG_DEBUG_UART_ANNOUNCE=y |
| CONFIG_ZYNQ_SERIAL=y |
