| /* | |
| * (C) Copyright 2009-2012 ADVANSEE | |
| * Benoît Thébaudeau <benoit.thebaudeau@advansee.com> | |
| * | |
| * Based on the Linux rtc-imxdi.c driver, which is: | |
| * Copyright 2008-2009 Freescale Semiconductor, Inc. All Rights Reserved. | |
| * Copyright 2010 Orex Computed Radiography | |
| * | |
| * SPDX-License-Identifier: GPL-2.0+ | |
| */ | |
| /* | |
| * Date & Time support for Freescale i.MX DryIce RTC | |
| */ | |
| #include <common.h> | |
| #include <command.h> | |
| #include <linux/compat.h> | |
| #include <rtc.h> | |
| #if defined(CONFIG_CMD_DATE) | |
| #include <asm/io.h> | |
| #include <asm/arch/imx-regs.h> | |
| /* DryIce Register Definitions */ | |
| struct imxdi_regs { | |
| u32 dtcmr; /* Time Counter MSB Reg */ | |
| u32 dtclr; /* Time Counter LSB Reg */ | |
| u32 dcamr; /* Clock Alarm MSB Reg */ | |
| u32 dcalr; /* Clock Alarm LSB Reg */ | |
| u32 dcr; /* Control Reg */ | |
| u32 dsr; /* Status Reg */ | |
| u32 dier; /* Interrupt Enable Reg */ | |
| }; | |
| #define DCAMR_UNSET 0xFFFFFFFF /* doomsday - 1 sec */ | |
| #define DCR_TCE (1 << 3) /* Time Counter Enable */ | |
| #define DSR_WBF (1 << 10) /* Write Busy Flag */ | |
| #define DSR_WNF (1 << 9) /* Write Next Flag */ | |
| #define DSR_WCF (1 << 8) /* Write Complete Flag */ | |
| #define DSR_WEF (1 << 7) /* Write Error Flag */ | |
| #define DSR_CAF (1 << 4) /* Clock Alarm Flag */ | |
| #define DSR_NVF (1 << 1) /* Non-Valid Flag */ | |
| #define DSR_SVF (1 << 0) /* Security Violation Flag */ | |
| #define DIER_WNIE (1 << 9) /* Write Next Interrupt Enable */ | |
| #define DIER_WCIE (1 << 8) /* Write Complete Interrupt Enable */ | |
| #define DIER_WEIE (1 << 7) /* Write Error Interrupt Enable */ | |
| #define DIER_CAIE (1 << 4) /* Clock Alarm Interrupt Enable */ | |
| /* Driver Private Data */ | |
| struct imxdi_data { | |
| struct imxdi_regs __iomem *regs; | |
| int init_done; | |
| }; | |
| static struct imxdi_data data; | |
| /* | |
| * This function attempts to clear the dryice write-error flag. | |
| * | |
| * A dryice write error is similar to a bus fault and should not occur in | |
| * normal operation. Clearing the flag requires another write, so the root | |
| * cause of the problem may need to be fixed before the flag can be cleared. | |
| */ | |
| static void clear_write_error(void) | |
| { | |
| int cnt; | |
| puts("### Warning: RTC - Register write error!\n"); | |
| /* clear the write error flag */ | |
| __raw_writel(DSR_WEF, &data.regs->dsr); | |
| /* wait for it to take effect */ | |
| for (cnt = 0; cnt < 1000; cnt++) { | |
| if ((__raw_readl(&data.regs->dsr) & DSR_WEF) == 0) | |
| return; | |
| udelay(10); | |
| } | |
| puts("### Error: RTC - Cannot clear write-error flag!\n"); | |
| } | |
| /* | |
| * Write a dryice register and wait until it completes. | |
| * | |
| * Use interrupt flags to determine when the write has completed. | |
| */ | |
| #define DI_WRITE_WAIT(val, reg) \ | |
| ( \ | |
| /* do the register write */ \ | |
| __raw_writel((val), &data.regs->reg), \ | |
| \ | |
| di_write_wait((val), #reg) \ | |
| ) | |
| static int di_write_wait(u32 val, const char *reg) | |
| { | |
| int cnt; | |
| int ret = 0; | |
| int rc = 0; | |
| /* wait for the write to finish */ | |
| for (cnt = 0; cnt < 100; cnt++) { | |
| if ((__raw_readl(&data.regs->dsr) & (DSR_WCF | DSR_WEF)) != 0) { | |
| ret = 1; | |
| break; | |
| } | |
| udelay(10); | |
| } | |
| if (ret == 0) | |
| printf("### Warning: RTC - Write-wait timeout " | |
| "val = 0x%.8x reg = %s\n", val, reg); | |
| /* check for write error */ | |
| if (__raw_readl(&data.regs->dsr) & DSR_WEF) { | |
| clear_write_error(); | |
| rc = -1; | |
| } | |
| return rc; | |
| } | |
| /* | |
| * Initialize dryice hardware | |
| */ | |
| static int di_init(void) | |
| { | |
| int rc = 0; | |
| data.regs = (struct imxdi_regs __iomem *)IMX_DRYICE_BASE; | |
| /* mask all interrupts */ | |
| __raw_writel(0, &data.regs->dier); | |
| /* put dryice into valid state */ | |
| if (__raw_readl(&data.regs->dsr) & DSR_NVF) { | |
| rc = DI_WRITE_WAIT(DSR_NVF | DSR_SVF, dsr); | |
| if (rc) | |
| goto err; | |
| } | |
| /* initialize alarm */ | |
| rc = DI_WRITE_WAIT(DCAMR_UNSET, dcamr); | |
| if (rc) | |
| goto err; | |
| rc = DI_WRITE_WAIT(0, dcalr); | |
| if (rc) | |
| goto err; | |
| /* clear alarm flag */ | |
| if (__raw_readl(&data.regs->dsr) & DSR_CAF) { | |
| rc = DI_WRITE_WAIT(DSR_CAF, dsr); | |
| if (rc) | |
| goto err; | |
| } | |
| /* the timer won't count if it has never been written to */ | |
| if (__raw_readl(&data.regs->dtcmr) == 0) { | |
| rc = DI_WRITE_WAIT(0, dtcmr); | |
| if (rc) | |
| goto err; | |
| } | |
| /* start keeping time */ | |
| if (!(__raw_readl(&data.regs->dcr) & DCR_TCE)) { | |
| rc = DI_WRITE_WAIT(__raw_readl(&data.regs->dcr) | DCR_TCE, dcr); | |
| if (rc) | |
| goto err; | |
| } | |
| data.init_done = 1; | |
| return 0; | |
| err: | |
| return rc; | |
| } | |
| int rtc_get(struct rtc_time *tmp) | |
| { | |
| unsigned long now; | |
| int rc = 0; | |
| if (!data.init_done) { | |
| rc = di_init(); | |
| if (rc) | |
| goto err; | |
| } | |
| now = __raw_readl(&data.regs->dtcmr); | |
| to_tm(now, tmp); | |
| err: | |
| return rc; | |
| } | |
| int rtc_set(struct rtc_time *tmp) | |
| { | |
| unsigned long now; | |
| int rc; | |
| if (!data.init_done) { | |
| rc = di_init(); | |
| if (rc) | |
| goto err; | |
| } | |
| now = mktime(tmp->tm_year, tmp->tm_mon, tmp->tm_mday, | |
| tmp->tm_hour, tmp->tm_min, tmp->tm_sec); | |
| /* zero the fractional part first */ | |
| rc = DI_WRITE_WAIT(0, dtclr); | |
| if (rc == 0) | |
| rc = DI_WRITE_WAIT(now, dtcmr); | |
| err: | |
| return rc; | |
| } | |
| void rtc_reset(void) | |
| { | |
| di_init(); | |
| } | |
| #endif |