powerpc/85xx: CONFIG_ENABLE_36BIT_PHYS does not depend on CONFIG_PHYS_64BIT

The macro CONFIG_ENABLE_36BIT_PHYS is used to indicate that the given SOC is
capable of 36-bit physical addresses, even if such large addresses are not
used.  On two boards, this macro was enabled only when building a 36-bit
image.

Signed-off-by: Timur Tabi <timur@freescale.com>
Signed-off-by: Kumar Gala <galak@kernel.crashing.org>

include/configs/P1022DS.h

diff --git a/include/configs/P1022DS.h b/include/configs/P1022DS.h
index d892b67..9620370 100644
--- a/include/configs/P1022DS.h
+++ b/include/configs/P1022DS.h
@@ -43,8 +43,9 @@
 #define CONFIG_FSL_PCIE_RESET		/* need PCIe reset errata */
 #define CONFIG_SYS_PCI_64BIT		/* enable 64-bit PCI resources */
 
-#ifdef CONFIG_PHYS_64BIT
 #define CONFIG_ENABLE_36BIT_PHYS
+
+#ifdef CONFIG_PHYS_64BIT
 #define CONFIG_ADDR_MAP
 #define CONFIG_SYS_NUM_ADDR_MAP		16	/* number of TLB1 entries */
 #endif

include/configs/p1_p2_rdb_pc.h

diff --git a/include/configs/p1_p2_rdb_pc.h b/include/configs/p1_p2_rdb_pc.h
index f1ef1df..b3d981f 100644
--- a/include/configs/p1_p2_rdb_pc.h
+++ b/include/configs/p1_p2_rdb_pc.h
@@ -204,9 +204,8 @@
 #define CONFIG_BTB
 
 #define CONFIG_BOARD_EARLY_INIT_F	/* Call board_pre_init */
-#ifdef CONFIG_PHYS_64BIT
+
 #define CONFIG_ENABLE_36BIT_PHYS
-#endif
 
 #ifdef CONFIG_PHYS_64BIT
 #define CONFIG_ADDR_MAP			1