blob: 00ee775a45150655840a137e7ec8ce5a4a7b6ed7 [file] [log] [blame]
/*
* (C) Copyright 2011
* Marvell Semiconductor <www.marvell.com>
* Written-by: Lei Wen <leiwen@marvell.com>
*
* SPDX-License-Identifier: GPL-2.0+
*/
/*
* This file should be included in board config header file.
*
* It supports common definitions for Armada XP platforms
*/
#ifndef _ARMADA_XP_CONFIG_H
#define _ARMADA_XP_CONFIG_H
#include <asm/arch/soc.h>
#define MV88F78X60 /* for the DDR training bin_hdr code */
#define CONFIG_SYS_CACHELINE_SIZE 32
/*
* By default kwbimage.cfg from board specific folder is used
* If for some board, different configuration file need to be used,
* CONFIG_SYS_KWD_CONFIG should be defined in board specific header file
*/
#ifndef CONFIG_SYS_KWD_CONFIG
#define CONFIG_SYS_KWD_CONFIG $(CONFIG_BOARDDIR)/kwbimage.cfg
#endif /* CONFIG_SYS_KWD_CONFIG */
/* Add target to build it automatically upon "make" */
#define CONFIG_BUILD_TARGET "u-boot.kwb"
/* end of 16M scrubbed by training in bootrom */
#define CONFIG_SYS_INIT_SP_ADDR 0x00FF0000
#define CONFIG_NR_DRAM_BANKS_MAX 2
#define MV_UART_CONSOLE_BASE MVEBU_UART0_BASE
/*
* SPI Flash configuration
*/
#ifdef CONFIG_CMD_SF
#define CONFIG_HARD_SPI 1
#define CONFIG_KIRKWOOD_SPI 1
#ifndef CONFIG_ENV_SPI_BUS
# define CONFIG_ENV_SPI_BUS 0
#endif
#ifndef CONFIG_ENV_SPI_CS
# define CONFIG_ENV_SPI_CS 0
#endif
#ifndef CONFIG_ENV_SPI_MAX_HZ
# define CONFIG_ENV_SPI_MAX_HZ 50000000
#endif
#endif
/*
* Ethernet Driver configuration
*/
#ifdef CONFIG_CMD_NET
#define CONFIG_CMD_MII
#define CONFIG_MII /* expose smi ove miiphy interface */
#define CONFIG_MVNETA /* Enable Marvell Gbe Controller Driver */
#define CONFIG_PHYLIB
#define CONFIG_ENV_OVERWRITE /* ethaddr can be reprogrammed */
#define CONFIG_PHY_GIGE /* GbE speed/duplex detect */
#endif /* CONFIG_CMD_NET */
/*
* I2C related stuff
*/
#ifdef CONFIG_CMD_I2C
#ifndef CONFIG_SYS_I2C_SOFT
#define CONFIG_I2C_MVTWSI
#endif
#define CONFIG_SYS_I2C_SLAVE 0x0
#define CONFIG_SYS_I2C_SPEED 100000
#endif
#endif /* _ARMADA_XP_CONFIG_H */