|README on how reset time on OMAPs should be calculated
|Most OMAPs' provide a way to specify the time for
|which the reset should be held low while the voltages
|and Oscillator outputs stabilize.
|This time is mostly board and PMIC dependent. Hence the
|boards are expected to specify a pre-computed time
|using the above option, (the details on how to compute
|the value are given below) without which a default time
|as specified by CONFIG_DEFAULT_OMAP_RESET_TIME_MAX_USEC
|The value for CONFIG_OMAP_PLATFORM_RESET_TIME_MAX_USEC
|can be computed using a summation of the below 3 parameters
|-1- Time taken by the Osciallator to stop and restart
|-2- PMIC OTP time
|-3- Voltage ramp time, which can be derived using the
|PMIC slew rate and value of voltage ramp needed.