include/configs/o2dnt2.h

/*
 * (C) Copyright 2012
 * DENX Software Engineering, Anatolij Gustschin <agust@denx.de>
 *
 * SPDX-License-Identifier:	GPL-2.0+
 */

/*
 * Valid values for CONFIG_SYS_TEXT_BASE are:
 * 0xFC000000   boot low boot high (standard configuration)
 * 0x00100000   boot from RAM (for testing only)
 */
#ifndef CONFIG_SYS_TEXT_BASE
#define CONFIG_SYS_TEXT_BASE	0xfc000000	/* Standard: boot low */
#endif

/* Board specific flash config */
#define CONFIG_SYS_FLASH_BASE		0xfc000000
#define CONFIG_SYS_FLASH_SIZE		0x04000000      /* maximum 64MB */
/* max number of sectors on one chip */
#define CONFIG_SYS_MAX_FLASH_SECT	512

/*
 * Include common defines for all ifm boards
 */
#include "o2dnt-common.h"

/* additional commands */
#define CONFIG_CMD_ITEST

/*
 * GPIO configuration:
 * CS1 SDRAM activate + no CAN + no PCI
 */
#define CONFIG_SYS_GPS_PORT_CONFIG	0x8000A004

/* Other board specific configs */
#define CONFIG_SYS_BOOTCS_CFG		0x00057d01
#define CONFIG_SYS_RESET_ADDRESS	0xfc000000

#define CONFIG_SYS_MEMTEST_START	0x00100000      /* memtest works on */
#define CONFIG_SYS_MEMTEST_END		0x07f00000	/* 1 - 127 MB in DRAM */

#define CONFIG_BOARD_NAME		"o2dnt2"
#define CONFIG_BOARD_BOOTCMD		"run flash_self"
#define CONFIG_BOARD_MEM_LIMIT		__stringify(126)
#define BOARD_POST_CRC32_END		__stringify(0x01000000)

#define CONFIG_EXTRA_ENV_SETTINGS					\
	CONFIG_IFM_DEFAULT_ENV_SETTINGS					\
	CONFIG_IFM_DEFAULT_ENV_OLD					\
	CONFIG_IFM_DEFAULT_ENV_NEW					\
	"linbot=fc060000\0"						\
	"lintop=fc15ffff\0"						\
	"rambot=fc160000\0"						\
	"ramtop=fc55ffff\0"						\
	"jffbot=fc560000\0"						\
	"jfftop=fce5ffff\0"						\
	"ubobot=" __stringify(CONFIG_SYS_FLASH_BASE) "\0"		\
	"ubotop=fc03ffff\0"						\
	"calname="CONFIG_BOARD_NAME"/uCal_"CONFIG_BOARD_NAME"_act\0"	\
	"calbot=fce60000\0"						\
	"caltop=fcffffff\0"						\
	"progCal=tftp 200000 ${calname};erase ${calbot} ${caltop};"	\
		"cp.b ${fileaddr} ${calbot} ${filesize}\0"		\
	"kernel_addr=0xfc060000\0"					\
	"ramdisk_addr=0xfc160000\0"					\
	"master=mw f0000b00 0x8005A006;mw f0000b0c ${IOpin};"		\
		"mw f0000b04 ${IOpin};mw f0000b10 0x20\0"