| How to use and build U-Boot on mx6sabreauto | |
| ------------------------------------------- | |
| mx6sabreauto_defconfig target supports mx6q/mx6dl/mx6qp sabreauto variants. | |
| In order to build it: | |
| $ make mx6sabreauto_defconfig | |
| $ make | |
| This will generate the SPL and u-boot.img binaries. | |
| - Flash the SPL binary into the SD card: | |
| $ sudo dd if=SPL of=/dev/sdX bs=1K seek=1 && sync | |
| - Flash the u-boot.img binary into the SD card: | |
| $ sudo dd if=u-boot.img of=/dev/sdX bs=1K seek=69 && sync | |
| Booting via Falcon mode | |
| ----------------------- | |
| Write in mx6sabreauto_defconfig the following define below: | |
| CONFIG_SPL_OS_BOOT=y | |
| In order to build it: | |
| $ make mx6sabreauto_defconfig | |
| $ make | |
| This will generate the SPL image called SPL and the u-boot.img. | |
| - Flash the SPL image into the SD card: | |
| $ sudo dd if=SPL of=/dev/sdb bs=1K seek=1 && sync | |
| - Flash the u-boot.img image into the SD card: | |
| $ sudo dd if=u-boot.img of=/dev/sdb bs=1K seek=69 && sync | |
| Create a FAT16 boot partition to store uImage and the dtb file, then copy the files there: | |
| $ sudo cp uImage /media/boot | |
| $ sudo cp imx6dl-sabreauto.dtb /media/boot | |
| Create a partition for root file system and extract it there: | |
| $ sudo tar xvf rootfs.tar.gz -C /media/root | |
| The SD card must have enough space for raw "args" and "kernel". | |
| To configure Falcon mode for the first time, on U-Boot do the following commands: | |
| - Load dtb file from boot partition: | |
| # load mmc 0:1 ${fdt_addr} imx6dl-sabreauto.dtb | |
| - Load kernel image from boot partition: | |
| # load mmc 0:1 ${loadaddr} uImage | |
| - Write kernel at 2MB offset: | |
| # mmc write ${loadaddr} 0x1000 0x4000 | |
| - Setup kernel bootargs: | |
| # setenv bootargs "console=ttymxc3,115200 root=/dev/mmcblk0p1 rootfstype=ext4 rootwait quiet rw" | |
| - Prepare args: | |
| # spl export fdt ${loadaddr} - ${fdt_addr} | |
| - Write args 1MB data (0x800 sectors) to 1MB offset (0x800 sectors) | |
| # mmc write 18000000 0x800 0x800 | |
| - Restart the board and then SPL binary will launch the kernel directly. |