| Board information | |
| ----------------- | |
| The SBC produced by Phytec has a SOM based on a i.MX6Q. | |
| The SOM is sold in two versions, with eMMC or with NAND. Support | |
| here is for the SOM with NAND. | |
| The evaluation board "phyBoard-Mira" is thought to be used | |
| together with the SOM. | |
| More information on the board can be found on manufacturer's | |
| website: | |
| http://www.phytec.de/produkt/single-board-computer/phyboard-mira/ | |
| http://www.phytec.de/fileadmin/user_upload/images/content/1.Products/SOMs/phyCORE-i.MX6/L-808e_1.pdf | |
| Building U-Boot | |
| ------------------------------- | |
| $ make pcm058_defconfig | |
| $ make | |
| This generates the artifacts SPL and u-boot.img. | |
| The SOM can boot from NAND or from SD-Card, having the SPI-NOR | |
| as second option. | |
| The dip switch "DIP-1" on the board let choose between | |
| NAND and SD. | |
| DIP-1 set to off: Boot first from NAND, then try SPI | |
| DIP-1 set to on: Boot first from SD, then try SPI | |
| The bootloader was tested with DIP-1 set to on. If a SD-card | |
| is present, then the RBL tries to load SPL from the SD Card, if not, | |
| RBL loads from SPI-NOR. The SPL tries then to load from the same | |
| device where SPL was loaded (SD or SPI). Booting from NAND is | |
| not supported. |