| CONFIG_ARM=y | |
| CONFIG_SYS_THUMB_BUILD=y | |
| # CONFIG_SPL_USE_ARCH_MEMCPY is not set | |
| # CONFIG_SPL_USE_ARCH_MEMSET is not set | |
| CONFIG_ARCH_AT91=y | |
| CONFIG_SYS_TEXT_BASE=0x72000000 | |
| CONFIG_TARGET_CORVUS=y | |
| CONFIG_SPL_GPIO_SUPPORT=y | |
| CONFIG_SPL_LIBCOMMON_SUPPORT=y | |
| CONFIG_SPL_LIBGENERIC_SUPPORT=y | |
| CONFIG_SYS_MALLOC_F_LEN=0x800 | |
| CONFIG_SPL_SERIAL_SUPPORT=y | |
| CONFIG_SPL=y | |
| CONFIG_NR_DRAM_BANKS=1 | |
| CONFIG_SYS_EXTRA_OPTIONS="AT91SAM9M10G45,MACH_TYPE=2066,SYS_USE_NANDFLASH" | |
| CONFIG_BOOTDELAY=3 | |
| CONFIG_USE_BOOTARGS=y | |
| CONFIG_BOOTARGS="console=ttyS0,115200 earlyprintk mtdparts=atmel_nand:256k(bootstrap)ro,512k(uboot)ro,256k(env),256k(env_redundant),256k(spare),512k(dtb),6M(kernel)ro,-(rootfs) root=/dev/mtdblock7 rw rootfstype=jffs2" | |
| # CONFIG_DISPLAY_BOARDINFO is not set | |
| CONFIG_BOARD_EARLY_INIT_F=y | |
| CONFIG_SPL_NAND_SUPPORT=y | |
| CONFIG_HUSH_PARSER=y | |
| CONFIG_SYS_PROMPT="U-Boot> " | |
| # CONFIG_CMD_BDI is not set | |
| CONFIG_CMD_BOOTZ=y | |
| # CONFIG_CMD_IMI is not set | |
| CONFIG_CMD_DFU=y | |
| CONFIG_CMD_GPIO=y | |
| # CONFIG_CMD_LOADS is not set | |
| CONFIG_CMD_NAND=y | |
| CONFIG_CMD_USB=y | |
| # CONFIG_CMD_SOURCE is not set | |
| # CONFIG_CMD_SETEXPR is not set | |
| CONFIG_CMD_DHCP=y | |
| CONFIG_CMD_PING=y | |
| CONFIG_CMD_MTDPARTS=y | |
| CONFIG_OF_CONTROL=y | |
| CONFIG_OF_EMBED=y | |
| CONFIG_DEFAULT_DEVICE_TREE="at91sam9g45-corvus" | |
| CONFIG_ENV_IS_IN_NAND=y | |
| CONFIG_CLK=y | |
| CONFIG_CLK_AT91=y | |
| CONFIG_DFU_NAND=y | |
| # CONFIG_MMC is not set | |
| CONFIG_NAND=y | |
| CONFIG_NAND_ATMEL=y | |
| CONFIG_PHYLIB=y | |
| CONFIG_ATMEL_USART=y | |
| CONFIG_USB=y | |
| CONFIG_USB_EHCI_HCD=y | |
| CONFIG_USB_STORAGE=y | |
| CONFIG_USB_GADGET=y | |
| CONFIG_USB_GADGET_MANUFACTURER="Siemens AG" | |
| CONFIG_USB_GADGET_VENDOR_NUM=0x0908 | |
| CONFIG_USB_GADGET_PRODUCT_NUM=0x02d2 | |
| CONFIG_USB_GADGET_ATMEL_USBA=y | |
| CONFIG_USB_GADGET_DOWNLOAD=y | |
| # CONFIG_EFI_LOADER is not set |