| # SPDX-License-Identifier: GPL-2.0+ | |
| # | |
| # Copyright (C) 2017, Tuomas Tynkkynen <tuomas.tynkkynen@iki.fi> | |
| U-Boot on QEMU's 'virt' machine on ARM & AArch64 | |
| ================================================ | |
| QEMU for ARM supports a special 'virt' machine designed for emulation and | |
| virtualization purposes. This document describes how to run U-Boot under it. | |
| Both 32-bit ARM and AArch64 are supported. | |
| The 'virt' platform provides the following as the basic functionality: | |
| - A freely configurable amount of CPU cores | |
| - U-Boot loaded and executing in the emulated flash at address 0x0 | |
| - A generated device tree blob placed at the start of RAM | |
| - A freely configurable amount of RAM, described by the DTB | |
| - A PL011 serial port, discoverable via the DTB | |
| - An ARMv7/ARMv8 architected timer | |
| - PSCI for rebooting the system | |
| - A generic ECAM-based PCI host controller, discoverable via the DTB | |
| Additionally, a number of optional peripherals can be added to the PCI bus. | |
| Building U-Boot | |
| --------------- | |
| Set the CROSS_COMPILE environment variable as usual, and run: | |
| - For ARM: | |
| make qemu_arm_defconfig | |
| make | |
| - For AArch64: | |
| make qemu_arm64_defconfig | |
| make | |
| Running U-Boot | |
| -------------- | |
| The minimal QEMU command line to get U-Boot up and running is: | |
| - For ARM: | |
| qemu-system-arm -machine virt -bios u-boot.bin | |
| - For AArch64: | |
| qemu-system-aarch64 -machine virt -cpu cortex-a57 -bios u-boot.bin | |
| Note that for some odd reason qemu-system-aarch64 needs to be explicitly | |
| told to use a 64-bit CPU or it will boot in 32-bit mode. | |
| Additional persistent U-boot environment support can be added as follows: | |
| - Create envstore.img using qemu-img: | |
| qemu-img create -f raw envstore.img 64M | |
| - Add a pflash drive parameter to the command line: | |
| -drive if=pflash,format=raw,index=1,file=envstore.img | |
| Additional peripherals that have been tested to work in both U-Boot and Linux | |
| can be enabled with the following command line parameters: | |
| - To add a Serial ATA disk via an Intel ICH9 AHCI controller, pass e.g.: | |
| -drive if=none,file=disk.img,id=mydisk -device ich9-ahci,id=ahci -device ide-drive,drive=mydisk,bus=ahci.0 | |
| - To add an Intel E1000 network adapter, pass e.g.: | |
| -netdev user,id=net0 -device e1000,netdev=net0 | |
| - To add an EHCI-compliant USB host controller, pass e.g.: | |
| -device usb-ehci,id=ehci | |
| - To add a NVMe disk, pass e.g.: | |
| -drive if=none,file=disk.img,id=mydisk -device nvme,drive=mydisk,serial=foo | |
| These have been tested in QEMU 2.9.0 but should work in at least 2.5.0 as well. |