| menu "Partition Types" | |
| config PARTITIONS | |
| bool "Enable Partition Labels (disklabels) support" | |
| default y | |
| select SPL_SPRINTF if SPL | |
| select TPL_SPRINTF if TPL | |
| select SPL_STRTO if SPL | |
| select TPL_STRTO if TPL | |
| help | |
| Partition Labels (disklabels) Supported: | |
| Zero or more of the following: | |
| - CONFIG_MAC_PARTITION Apple's MacOS partition table. | |
| - CONFIG_DOS_PARTITION MS Dos partition table, traditional on the | |
| Intel architecture, USB sticks, etc. | |
| - CONFIG_ISO_PARTITION ISO partition table, used on CDROM etc. | |
| - CONFIG_EFI_PARTITION GPT partition table, common when EFI is the | |
| bootloader. Note 2TB partition limit; see | |
| disk/part_efi.c | |
| - CONFIG_MTD_PARTITIONS Memory Technology Device partition table. | |
| If IDE or SCSI support is enabled (CONFIG_CMD_IDE or CONFIG_SCSI) | |
| you must configure support for at least one non-MTD partition type | |
| as well. | |
| config MAC_PARTITION | |
| bool "Enable Apple's MacOS partition table" | |
| depends on PARTITIONS | |
| help | |
| Say Y here if you would like to use device under U-Boot which | |
| were partitioned on a Macintosh. | |
| config SPL_MAC_PARTITION | |
| bool "Enable Apple's MacOS partition table for SPL" | |
| depends on SPL && PARTITIONS | |
| default y if MAC_PARTITION | |
| config DOS_PARTITION | |
| bool "Enable MS Dos partition table" | |
| depends on PARTITIONS | |
| default y if DISTRO_DEFAULTS | |
| default y if x86 || CMD_FAT || USB_STORAGE | |
| help | |
| traditional on the Intel architecture, USB sticks, etc. | |
| config SPL_DOS_PARTITION | |
| bool "Enable MS Dos partition table for SPL" | |
| depends on SPL && PARTITIONS | |
| default y if DOS_PARTITION | |
| config ISO_PARTITION | |
| bool "Enable ISO partition table" | |
| depends on PARTITIONS | |
| default y if DISTRO_DEFAULTS | |
| default y if MIPS || TEGRA | |
| config SPL_ISO_PARTITION | |
| bool "Enable ISO partition table for SPL" | |
| depends on SPL && PARTITIONS | |
| config AMIGA_PARTITION | |
| bool "Enable AMIGA partition table" | |
| depends on PARTITIONS | |
| help | |
| Say Y here if you would like to use device under U-Boot which | |
| were partitioned under AmigaOS. | |
| config SPL_AMIGA_PARTITION | |
| bool "Enable AMIGA partition table for SPL" | |
| depends on SPL && PARTITIONS | |
| default y if AMIGA_PARTITION | |
| config EFI_PARTITION | |
| bool "Enable EFI GPT partition table" | |
| depends on PARTITIONS | |
| default y if DISTRO_DEFAULTS | |
| default y if TEGRA | |
| default y if AML_GPT | |
| select LIB_UUID | |
| help | |
| Say Y here if you would like to use device under U-Boot which | |
| were partitioned using EFI GPT. | |
| common when EFI is the bootloader. Note 2TB partition limit; | |
| see disk/part_efi.c | |
| config EFI_PARTITION_ENTRIES_NUMBERS | |
| int "Number of the EFI partition entries" | |
| depends on EFI_PARTITION | |
| default 56 if ARCH_SUNXI | |
| default 128 | |
| help | |
| Specify the number of partition entries in the GPT. This is | |
| meant to allow less than the standard specifies for devices | |
| that might need to place their first-stage bootloader in the | |
| middle of a regular GPT. | |
| If unsure, leave at 128 entries, which is the standard | |
| number. | |
| config EFI_PARTITION_ENTRIES_OFF | |
| int "Offset (in bytes) of the EFI partition entries" | |
| depends on EFI_PARTITION | |
| default 0 | |
| help | |
| Specify an earliest location (in bytes) where the partition | |
| entries may be located. This is meant to allow "punching a | |
| hole into a device" to create a gap for an SPL, its payload | |
| and the U-Boot environment. | |
| If unsure, leave at 0 (which will locate the partition | |
| entries at the first possible LBA following the GPT header). | |
| config SPL_EFI_PARTITION | |
| bool "Enable EFI GPT partition table for SPL" | |
| depends on SPL && PARTITIONS | |
| default y if EFI_PARTITION | |
| config PARTITION_UUIDS | |
| bool "Enable support of UUID for partition" | |
| depends on PARTITIONS | |
| default y if DISTRO_DEFAULTS | |
| default y if EFI_PARTITION | |
| select LIB_UUID | |
| help | |
| Activate the configuration of UUID for partition | |
| config SPL_PARTITION_UUIDS | |
| bool "Enable support of UUID for partition in SPL" | |
| depends on SPL && PARTITIONS | |
| default y if SPL_EFI_PARTITION | |
| config PARTITION_TYPE_GUID | |
| bool "Enable support of GUID for partition type" | |
| depends on PARTITIONS | |
| depends on EFI_PARTITION | |
| default y if AML_GPT | |
| help | |
| Activate the configuration of GUID type | |
| for EFI partition | |
| config AML_PARTITION | |
| bool "Enable AML partition table" | |
| depends on PARTITIONS | |
| help | |
| config AML_GPT | |
| bool "Enable AML GPT partition table" | |
| depends on PARTITIONS | |
| help | |
| endmenu |