| How to port a serial driver to driver model |
| =========================================== |
| |
| Over half of the I2C drivers have been converted as at November 2016. These |
| ones remain: |
| |
| adi_i2c |
| davinci_i2c |
| fti2c010 |
| ihs_i2c |
| kona_i2c |
| lpc32xx_i2c |
| pca9564_i2c |
| ppc4xx_i2c |
| rcar_i2c |
| sh_i2c |
| sh_sh7734_i2c |
| soft_i2c |
| tsi108_i2c |
| zynq_i2c |
| |
| The deadline for this work is the end of June 2017. If no one steps |
| forward to convert these, at some point there may come a patch to remove them! |
| |
| Here is a suggested approach for converting your I2C driver over to driver |
| model. Please feel free to update this file with your ideas and suggestions. |
| |
| - #ifdef out all your own I2C driver code (#ifndef CONFIG_DM_I2C) |
| - Define CONFIG_DM_I2C for your board, vendor or architecture |
| - If the board does not already use driver model, you need CONFIG_DM also |
| - Your board should then build, but will not work fully since there will be |
| no I2C driver |
| - Add the U_BOOT_DRIVER piece at the end (e.g. copy tegra_i2c.c for example) |
| - Add a private struct for the driver data - avoid using static variables |
| - Implement each of the driver methods, perhaps by calling your old methods |
| - You may need to adjust the function parameters so that the old and new |
| implementations can share most of the existing code |
| - If you convert all existing users of the driver, remove the pre-driver-model |
| code |
| |
| In terms of patches a conversion series typically has these patches: |
| - clean up / prepare the driver for conversion |
| - add driver model code |
| - convert at least one existing board to use driver model serial |
| - (if no boards remain that don't use driver model) remove the old code |
| |
| This may be a good time to move your board to use device tree also. Mostly |
| this involves these steps: |
| |
| - define CONFIG_OF_CONTROL and CONFIG_OF_SEPARATE |
| - add your device tree files to arch/<arch>/dts |
| - update the Makefile there |
| - Add stdout-path to your /chosen device tree node if it is not already there |
| - build and get u-boot-dtb.bin so you can test it |
| - Your drivers can now use device tree |
| - For device tree in SPL, define CONFIG_SPL_OF_CONTROL |
