| Summary | |
| ======= | |
| LEGO MINDSTORMS EV3 is a toy robot produced by the LEGO Group. It is based | |
| on the davinci da850 evm. The EV3 has a 16MB spi flash and a SDHC microSD card | |
| reader. | |
| Booting | |
| ======= | |
| The EV3 contains a bootloader in EEPROM that loads u-boot.bin from address 0x0 | |
| of the SPI flash memory (with a size of 256KiB!). Because the EEPROM is read- | |
| only and it takes care of low level configuration (PLL and DDR), we don't use | |
| U-Boot to produce an SPL image. | |
| Using the default configuration, U-Boot had a boot scrips that works as follows: | |
| * Check to see if microSD card is present | |
| * If it is, try to load boot.scr from the first FAT partition | |
| * If loading boot.scr was successful, run it | |
| * Otherwise, try loading uEnv.txt | |
| * If loading uEnv.txt was successful, import it | |
| * If there is a uenvcmd variable (from uEnv.txt), run it | |
| * Try to load uImage from the first FAT partition | |
| * If it was successful, try to load da850-lego-ev3.dtb | |
| * If loading uImage was successful, boot it (DT is optional) | |
| * If none of the above was successful, try booting from flash | |
| Suggested Flash Memory Layout | |
| ============================= | |
| The following is based on the default U-Boot configuration: | |
| | Image (file) | Start Addr. | Max. Size | | |
| +--------------------+-------------+-------------------+ | |
| | u-boot.bin | 0x0 | 0x40000 (256KiB) | | |
| | da850-lego-ev3.dtb | 0x40000 | 0x10000 (64KiB) | | |
| | uImage | 0x50000 | 0x400000 (4MiB) | | |
| | rootfs (squashfs) | 0x450000 | 0xa00000 (10MiB) | | |
| Writing image to flash | |
| ====================== | |
| The EEPROM contains a program for uploading an image file to the flash memory. | |
| The program is started by holding down the right button on the EV3 when powering | |
| it on. You can also `run fwupdateboot` in the u-boot shell to reboot into this | |
| mode. The image can then be uploaded using the official LEGO MINDSTORMS EV3 | |
| software or a 3rd party program capable of uploading a firmware file. | |
| If you are booting from the microSD card, it is enough to just write uboot.bin | |
| to the flash. If you are not using a microSD card, you will need to create an | |
| image file using the layout described above. | |
| IMPORTANT: The EEPROM bootloader only copies 256k, so u-boot.img must not | |
| exceed that size! |