| # | |
| # Copyright (C) 2014, Bin Meng <bmeng.cn@gmail.com> | |
| # | |
| # SPDX-License-Identifier: GPL-2.0+ | |
| # | |
| config INTEL_QUEENSBAY | |
| bool | |
| select HAVE_FSP | |
| select HAVE_CMC | |
| if INTEL_QUEENSBAY | |
| config HAVE_FSP | |
| bool "Add an Firmware Support Package binary" | |
| help | |
| Select this option to add an Firmware Support Package binary to | |
| the resulting U-Boot image. It is a binary blob which U-Boot uses | |
| to set up SDRAM and other chipset specific initialization. | |
| Note: Without this binary U-Boot will not be able to set up its | |
| SDRAM so will not boot. | |
| config FSP_FILE | |
| string "Firmware Support Package binary filename" | |
| depends on HAVE_FSP | |
| default "fsp.bin" | |
| help | |
| The filename of the file to use as Firmware Support Package binary | |
| in the board directory. | |
| config FSP_ADDR | |
| hex "Firmware Support Package binary location" | |
| depends on HAVE_FSP | |
| default 0xfffc0000 | |
| help | |
| FSP is not Position Independent Code (PIC) and the whole FSP has to | |
| be rebased if it is placed at a location which is different from the | |
| perferred base address specified during the FSP build. Use Intel's | |
| Binary Configuration Tool (BCT) to do the rebase. | |
| The default base address of 0xfffc0000 indicates that the binary must | |
| be located at offset 0xc0000 from the beginning of a 1MB flash device. | |
| config FSP_TEMP_RAM_ADDR | |
| hex | |
| default 0x2000000 | |
| help | |
| Stack top address which is used in FspInit after DRAM is ready and | |
| CAR is disabled. | |
| config HAVE_CMC | |
| bool "Add a Chipset Micro Code state machine binary" | |
| help | |
| Select this option to add a Chipset Micro Code state machine binary | |
| to the resulting U-Boot image. It is a 64K data block of machine | |
| specific code which must be put in the flash for the processor to | |
| access when powered up before system BIOS is executed. | |
| config CMC_FILE | |
| string "Chipset Micro Code state machine filename" | |
| depends on HAVE_CMC | |
| default "cmc.bin" | |
| help | |
| The filename of the file to use as Chipset Micro Code state machine | |
| binary in the board directory. | |
| config CMC_ADDR | |
| hex "Chipset Micro Code state machine binary location" | |
| depends on HAVE_CMC | |
| default 0xfffb0000 | |
| help | |
| The location of the CMC binary is determined by a strap. It must be | |
| put in flash at a location matching the strap-determined base address. | |
| The default base address of 0xfffb0000 indicates that the binary must | |
| be located at offset 0xb0000 from the beginning of a 1MB flash device. | |
| endif |