| /* |
| * (C) Copyright 2013 |
| * Texas Instruments Incorporated. |
| * Lokesh Vutla <lokeshvutla@ti.com> |
| * |
| * Configuration settings for the TI DRA7XX board. |
| * See ti_omap5_common.h for omap5 common settings. |
| * |
| * SPDX-License-Identifier: GPL-2.0+ |
| */ |
| |
| #ifndef __CONFIG_DRA7XX_EVM_H |
| #define __CONFIG_DRA7XX_EVM_H |
| |
| #define CONFIG_DRA7XX |
| #define CONFIG_BOARD_EARLY_INIT_F |
| |
| #ifndef CONFIG_QSPI_BOOT |
| /* MMC ENV related defines */ |
| #define CONFIG_ENV_IS_IN_MMC |
| #define CONFIG_SYS_MMC_ENV_DEV 1 /* SLOT2: eMMC(1) */ |
| #define CONFIG_ENV_SIZE (128 << 10) |
| #define CONFIG_ENV_OFFSET 0xE0000 |
| #define CONFIG_ENV_OFFSET_REDUND (CONFIG_ENV_OFFSET + CONFIG_ENV_SIZE) |
| #define CONFIG_SYS_REDUNDAND_ENVIRONMENT |
| #endif |
| #define CONFIG_CMD_SAVEENV |
| |
| #if (CONFIG_CONS_INDEX == 1) |
| #define CONSOLEDEV "ttyO0" |
| #elif (CONFIG_CONS_INDEX == 3) |
| #define CONSOLEDEV "ttyO2" |
| #endif |
| #define CONFIG_SYS_NS16550_COM1 UART1_BASE /* Base EVM has UART0 */ |
| #define CONFIG_SYS_NS16550_COM2 UART2_BASE /* UART2 */ |
| #define CONFIG_SYS_NS16550_COM3 UART3_BASE /* UART3 */ |
| #define CONFIG_BAUDRATE 115200 |
| |
| #define CONFIG_SYS_OMAP_ABE_SYSCK |
| |
| /* Define the default GPT table for eMMC */ |
| #define PARTS_DEFAULT \ |
| "uuid_disk=${uuid_gpt_disk};" \ |
| "name=rootfs,start=2MiB,size=-,uuid=${uuid_gpt_rootfs}" |
| |
| #include <configs/ti_omap5_common.h> |
| |
| /* Enhance our eMMC support / experience. */ |
| #define CONFIG_CMD_GPT |
| #define CONFIG_EFI_PARTITION |
| #define CONFIG_HSMMC2_8BIT |
| |
| /* CPSW Ethernet */ |
| #define CONFIG_CMD_NET /* 'bootp' and 'tftp' */ |
| #define CONFIG_CMD_DHCP |
| #define CONFIG_BOOTP_DNS /* Configurable parts of CMD_DHCP */ |
| #define CONFIG_BOOTP_DNS2 |
| #define CONFIG_BOOTP_SEND_HOSTNAME |
| #define CONFIG_BOOTP_GATEWAY |
| #define CONFIG_BOOTP_SUBNETMASK |
| #define CONFIG_NET_RETRY_COUNT 10 |
| #define CONFIG_CMD_PING |
| #define CONFIG_CMD_MII |
| #define CONFIG_DRIVER_TI_CPSW /* Driver for IP block */ |
| #define CONFIG_MII /* Required in net/eth.c */ |
| #define CONFIG_PHY_GIGE /* per-board part of CPSW */ |
| #define CONFIG_PHYLIB |
| |
| /* SPI */ |
| #undef CONFIG_OMAP3_SPI |
| #define CONFIG_TI_QSPI |
| #define CONFIG_SPI_FLASH |
| #define CONFIG_SPI_FLASH_SPANSION |
| #define CONFIG_CMD_SF |
| #define CONFIG_CMD_SPI |
| #define CONFIG_SPI_FLASH_BAR |
| #define CONFIG_TI_SPI_MMAP |
| #define CONFIG_SF_DEFAULT_SPEED 48000000 |
| #define CONFIG_DEFAULT_SPI_MODE SPI_MODE_3 |
| |
| /* |
| * Default to using SPI for environment, etc. |
| * 0x000000 - 0x010000 : QSPI.SPL (64KiB) |
| * 0x010000 - 0x020000 : QSPI.SPL.backup1 (64KiB) |
| * 0x020000 - 0x030000 : QSPI.SPL.backup2 (64KiB) |
| * 0x030000 - 0x040000 : QSPI.SPL.backup3 (64KiB) |
| * 0x040000 - 0x140000 : QSPI.u-boot (1MiB) |
| * 0x140000 - 0x1C0000 : QSPI.u-boot-spl-os (512KiB) |
| * 0x1C0000 - 0x1D0000 : QSPI.u-boot-env (64KiB) |
| * 0x1D0000 - 0x1E0000 : QSPI.u-boot-env.backup1 (64KiB) |
| * 0x1E0000 - 0x9E0000 : QSPI.kernel (8MiB) |
| * 0x9E0000 - 0x2000000 : USERLAND |
| */ |
| #define CONFIG_SYS_SPI_KERNEL_OFFS 0x1E0000 |
| #define CONFIG_SYS_SPI_ARGS_OFFS 0x140000 |
| #define CONFIG_SYS_SPI_ARGS_SIZE 0x80000 |
| #if defined(CONFIG_QSPI_BOOT) |
| /* In SPL, use the environment and discard MMC support for space. */ |
| #ifdef CONFIG_SPL_BUILD |
| #undef CONFIG_SPL_MMC_SUPPORT |
| #undef CONFIG_SPL_MAX_SIZE |
| #define CONFIG_SPL_MAX_SIZE (64 << 10) /* 64 KiB */ |
| #endif |
| #define CONFIG_SPL_ENV_SUPPORT |
| #define CONFIG_ENV_IS_IN_SPI_FLASH |
| #define CONFIG_SYS_REDUNDAND_ENVIRONMENT |
| #define CONFIG_ENV_SPI_MAX_HZ CONFIG_SF_DEFAULT_SPEED |
| #define CONFIG_ENV_SIZE (64 << 10) |
| #define CONFIG_ENV_SECT_SIZE (64 << 10) /* 64 KB sectors */ |
| #define CONFIG_ENV_OFFSET 0x1C0000 |
| #define CONFIG_ENV_OFFSET_REDUND 0x1D0000 |
| #endif |
| |
| /* SPI SPL */ |
| #define CONFIG_SPL_SPI_SUPPORT |
| #define CONFIG_SPL_SPI_LOAD |
| #define CONFIG_SPL_SPI_FLASH_SUPPORT |
| #define CONFIG_SYS_SPI_U_BOOT_OFFS 0x40000 |
| |
| #define CONFIG_SUPPORT_EMMC_BOOT |
| |
| /* USB xHCI HOST */ |
| #define CONFIG_CMD_USB |
| #define CONFIG_USB_HOST |
| #define CONFIG_USB_XHCI |
| #define CONFIG_USB_XHCI_OMAP |
| #define CONFIG_USB_STORAGE |
| #define CONFIG_SYS_USB_XHCI_MAX_ROOT_PORTS 2 |
| |
| #define CONFIG_OMAP_USB_PHY |
| #define CONFIG_OMAP_USB2PHY2_HOST |
| |
| /* SATA */ |
| #define CONFIG_BOARD_LATE_INIT |
| #define CONFIG_CMD_SCSI |
| #define CONFIG_LIBATA |
| #define CONFIG_SCSI_AHCI |
| #define CONFIG_SCSI_AHCI_PLAT |
| #define CONFIG_SYS_SCSI_MAX_SCSI_ID 1 |
| #define CONFIG_SYS_SCSI_MAX_LUN 1 |
| #define CONFIG_SYS_SCSI_MAX_DEVICE (CONFIG_SYS_SCSI_MAX_SCSI_ID * \ |
| CONFIG_SYS_SCSI_MAX_LUN) |
| |
| /* NAND support */ |
| #ifdef CONFIG_NAND |
| /* NAND: device related configs */ |
| #define CONFIG_SYS_NAND_PAGE_SIZE 2048 |
| #define CONFIG_SYS_NAND_OOBSIZE 64 |
| #define CONFIG_SYS_NAND_BLOCK_SIZE (128*1024) |
| #define CONFIG_SYS_NAND_BUSWIDTH_16BIT |
| #define CONFIG_SYS_NAND_PAGE_COUNT (CONFIG_SYS_NAND_BLOCK_SIZE / \ |
| CONFIG_SYS_NAND_PAGE_SIZE) |
| #define CONFIG_SYS_NAND_5_ADDR_CYCLE |
| /* NAND: driver related configs */ |
| #define CONFIG_NAND_OMAP_GPMC |
| #define CONFIG_NAND_OMAP_ELM |
| #define CONFIG_SYS_NAND_ONFI_DETECTION |
| #define CONFIG_NAND_OMAP_ECCSCHEME OMAP_ECC_BCH8_CODE_HW |
| #define CONFIG_SYS_NAND_BAD_BLOCK_POS NAND_LARGE_BADBLOCK_POS |
| #define CONFIG_SYS_NAND_ECCPOS { 2, 3, 4, 5, 6, 7, 8, 9, \ |
| 10, 11, 12, 13, 14, 15, 16, 17, \ |
| 18, 19, 20, 21, 22, 23, 24, 25, \ |
| 26, 27, 28, 29, 30, 31, 32, 33, \ |
| 34, 35, 36, 37, 38, 39, 40, 41, \ |
| 42, 43, 44, 45, 46, 47, 48, 49, \ |
| 50, 51, 52, 53, 54, 55, 56, 57, } |
| #define CONFIG_SYS_NAND_ECCSIZE 512 |
| #define CONFIG_SYS_NAND_ECCBYTES 14 |
| #define MTDIDS_DEFAULT "nand0=nand.0" |
| #define MTDPARTS_DEFAULT "mtdparts=nand.0:" \ |
| "128k(NAND.SPL)," \ |
| "128k(NAND.SPL.backup1)," \ |
| "128k(NAND.SPL.backup2)," \ |
| "128k(NAND.SPL.backup3)," \ |
| "256k(NAND.u-boot-spl-os)," \ |
| "1m(NAND.u-boot)," \ |
| "128k(NAND.u-boot-env)," \ |
| "128k(NAND.u-boot-env.backup1)," \ |
| "8m(NAND.kernel)," \ |
| "-(NAND.rootfs)" |
| #define CONFIG_SYS_NAND_U_BOOT_OFFS 0x000c0000 |
| /* NAND: SPL related configs */ |
| #ifdef CONFIG_SPL_NAND_SUPPORT |
| #define CONFIG_SPL_NAND_AM33XX_BCH |
| #endif |
| /* NAND: SPL falcon mode configs */ |
| #ifdef CONFIG_SPL_OS_BOOT |
| #define CONFIG_CMD_SPL_NAND_OFS 0x00080000 /* os-boot params*/ |
| #define CONFIG_SYS_NAND_SPL_KERNEL_OFFS 0x00200000 /* kernel offset */ |
| #define CONFIG_CMD_SPL_WRITE_SIZE 0x2000 |
| #endif |
| #endif /* !CONFIG_NAND */ |
| |
| /* Parallel NOR Support */ |
| #if defined(CONFIG_NOR) |
| /* NOR: device related configs */ |
| #define CONFIG_SYS_MAX_FLASH_SECT 512 |
| #define CONFIG_SYS_FLASH_CFI_WIDTH FLASH_CFI_16BIT |
| #define CONFIG_SYS_FLASH_SIZE (64 * 1024 * 1024) /* 64 MB */ |
| /* #define CONFIG_INIT_IGNORE_ERROR */ |
| #undef CONFIG_SYS_NO_FLASH |
| #define CONFIG_CMD_FLASH |
| #define CONFIG_SYS_FLASH_USE_BUFFER_WRITE |
| #define CONFIG_SYS_FLASH_PROTECTION |
| #define CONFIG_SYS_FLASH_CFI |
| #define CONFIG_FLASH_CFI_DRIVER |
| #define CONFIG_FLASH_CFI_MTD |
| #define CONFIG_SYS_MAX_FLASH_BANKS 1 |
| #define CONFIG_SYS_FLASH_BASE (0x08000000) |
| #define CONFIG_SYS_MONITOR_BASE CONFIG_SYS_FLASH_BASE |
| /* Reduce SPL size by removing unlikey targets */ |
| #ifdef CONFIG_NOR_BOOT |
| #define CONFIG_ENV_IS_IN_FLASH |
| #define CONFIG_ENV_SECT_SIZE (128 * 1024) /* 128 KiB */ |
| #define MTDIDS_DEFAULT "nor0=physmap-flash.0" |
| #define MTDPARTS_DEFAULT "mtdparts=physmap-flash.0:" \ |
| "128k(NOR.SPL)," \ |
| "128k(NOR.SPL.backup1)," \ |
| "128k(NOR.SPL.backup2)," \ |
| "128k(NOR.SPL.backup3)," \ |
| "256k(NOR.u-boot-spl-os)," \ |
| "1m(NOR.u-boot)," \ |
| "128k(NOR.u-boot-env)," \ |
| "128k(NOR.u-boot-env.backup1)," \ |
| "8m(NOR.kernel)," \ |
| "-(NOR.rootfs)" |
| #define CONFIG_ENV_OFFSET 0x001c0000 |
| #define CONFIG_ENV_OFFSET_REDUND 0x001e0000 |
| #endif |
| #endif /* NOR support */ |
| |
| #endif /* __CONFIG_DRA7XX_EVM_H */ |
